What if no plateau observed in ist cycle in lithium ion half cell for carbon as anode?

What is possible if no plateau observed in ist discharge cycle carbon as anode in lithium ion half cell. however irreversible capacity loss occurs

06 July 2017 2,804 3 View

Can someone explain lithium half cell reaction for carbon as anode

is immediately after cell fabrication the li ion goes to the carbon? and so when we carried out first cycle it is discharging (lithium goes back to anode). or in discharging lithium ions got...

05 June 2017 6,056 9 View

What is Significance of peaks at 42 and 44 in Carbon XRD spectra?

06 July 2016 3,510 9 View

What kind of defects can be observed in graphite interlayers. can these be observed using HRTEM?

01 January 1970 3,766 2 View

What is the density for pva electrospining?

I'm Juan Carlos, a high school student who is working with electropinning, I made an electropinning machine with a 21g needle and a 30kv high voltage source and the distance between my needle is...

28 February 2021 298 3 View

No title

I am trying to find how to know the density needed for a pva electrospinning in a 0.6mm neddle, the electrospinning will be from top to bottom and the problem I really have is the solution because...

25 February 2021 2,615 3 View

Is nanotechnology part of materials science? Is it possible to obtain Pico technology and move from hypothesis to application?

Pico-scale This is three orders of magnitude smaller than a nanometer (and thus most nanotechnology) and two orders of magnitude smaller than most chemistry transformations and measurements. Pico...

18 February 2021 4,540 5 View

Could you please suggest to me an interesting and good book about Nanotechnology?

I want to know about nanotechnology from beginning to professional. Thus I want some book in this area

01 February 2021 1,889 13 View

Dear Colleagues, I am looking for a way to dop of electrospining nanofibers on the HEPA filter.Someone can guide me?

Electrospining method is important for production of nanofiber .If doped with nanoparticles ,can be used for remove of contaminant such as VOC , but don't have mechanical strengh . For finding a...

24 January 2021 7,290 3 View

How Nanotechnology helps to develop various products in Agrometeorology?

Nanotechnology (NT) is one of the advanced material science with which the development in materials and improvement in electronics. NT has made it possible to miniaturizing the things to fit in...

21 January 2021 2,305 6 View

What is the current situation in the development of nanofibers laminated and biodegradable material based facemasks?

I want to know the progress in the development of polymer laminated, biodegradable material based facemasks.

18 January 2021 9,205 3 View

What could be the appropriate load and loading rate to carried out nanoindentation for testing microhardness of nanofiber?

Dear Reader, Recently, I have prepared a polymeric nanofiber using PVA polymer doped with some nanoparticles and I want to find out its microhardness. So, I was planning to do...

09 January 2021 4,452 7 View

Why the bandgap of CH3NH3PbCl3 films are different for spin-coating method and electrospinning method?

The observed bandgaps are 3.8 eV and 3.4 eV for spin-coated and electrospun films, respectively. What are the possible reasons?

08 January 2021 5,646 6 View

How can I take an electrical conductivity test from a nanofibrous scaffold?

I have a nanofiber scaffold for tissue engineering. When I did the electrical conductivity test, the ohmmeter reports a wide range of values (from 300 kOhm to 20 MOhm). I placed the scaffold...

06 January 2021 2,232 1 View