The discussion is closed as per the valuable suggestion of Professor Pawan Kumar Khanna.
I thank him for enlightening me.
I don't think it right for student to search for his thesis evaluater.
You should leave it to supervisor and examination cell.
Providing 8 names is guides responsibility and not yours. University is asking guide.
It is misinterpreted by students as well as guide.
It is supposed to be confidential and should not be discussed in public platform.
Request your guide to take care
Thank you Professor.
I would do the needful and close the discussion as per your suggestion.
Am thankful to you in this regard.
Dear Researchers & Professors, Please let me know the answers for the following queries. 1. What do we mean by the hardness of a nanoparticle? 2. If the hardness of Al2O3 nanoparticle is...
04 May 2019 7,390 4 View
Please let me know the Cp value of CNT and Aluminium nitride nanoparticles.
04 May 2019 6,804 4 View
I have been provided with a data sheet with Intensity % and particle size in nm. Can anyone help me out to to figure the ways by which I could calculate the average particle size from it? I need...
02 March 2018 1,917 7 View
I request someone to list the institutions and/or labs, which can help me utilize Furnace (upto 1000 deg.C), SEM (magnification upto nano size), XRD, pH, Zeta Potential DLS for powder samples and...
04 May 2016 2,011 5 View
02 March 2016 7,943 4 View
Dear Researchers and Professors, I dispersed 0.5 gms of MgO in a litre of DI water and sonicated it for 3 hours and found that, it did not disperse well. After keeping it idle for a day, found...
02 March 2016 145 3 View
Can some one provide me with full research papers on flow of conventional fluid and Nanofluid through ducts? Any number of papers as much possible.
08 September 2015 8,100 0 View
Please suggest each basic step to prepare a nanofluid for Forced Convection Test Loop setup. How much quantity of nanofluid is needed for the test loop? How much nanoparticle is to be taken to...
06 July 2015 1,480 2 View
I wish to know whether a synthesized nanoparticle can be used as effective nanofluid for thermal and electrical application. Also I am in need of the measurement techniques available and can be...
06 July 2015 6,397 8 View
Dear Professors & Researchers, Can anyone kindly provide me with a list of good plagiarism check software, which would be affordable for me to buy and install in my personal...
01 January 1970 6,567 8 View
I have conducted and published a systematic review and meta-analysis research with the topic related to public health and health pomotion (protocol was registed in PROSPERO). Now we want to...
03 March 2021 8,920 3 View
How to upload pdf of my articles published?
03 March 2021 2,183 3 View
I anwar by adsorption or reaction ..but it is either more method...
02 March 2021 4,811 2 View
I took measurements of different concentrations of 15 nm and 5 nm Au nano particle solutions. I'm trying to determine which concentration I measured gives the best reading overall. I also...
02 March 2021 7,626 1 View
There are some books published in LAP. Shall I add it to the RG?
02 March 2021 2,753 1 View
it is published by Juniper
28 February 2021 354 4 View
Dear all I am going to publish my manuscript which is from my thesis in a good H-Index journal but I found them very expensive(I don't have financial support) based on the exchange currency of my...
28 February 2021 7,800 6 View
We have seen some authors use some software to write review paper. As obvious, the study of all published papers concerning our studying field is not possible and these software can help us to...
27 February 2021 6,296 1 View
I want to publish paper in journal but I have figures which have drawn with bio-renders, can I put them in the paper or which other software I can use to draw them?
27 February 2021 8,179 1 View
Good day to all, I have no experience with light emitting diodes. I am building a glass mini flume to demonstrate the photo degradation of Methylene Blue in water running over self cleaning...
26 February 2021 4,026 5 View