Could it be possible that the IS in Mossbauer spectro data is a negative value?

Xiong Xiong @Xiong-Xiong-26

01 January 1970 0 2K Report

Will alpha-iron calibration at different speed result in big difference?

Badges
Science topic

Similar topics
Phytochemistry
Extracts

More Xiong Xiong's questions See All

Tissue homogenization in mouse with FastPrep-24™ 5G - is the D matrix system useful?

I need to lyse and homogenise mouse tissues. So far I have experimented with liver and lung tissue, using matrix D. The liver was completely lysed with 6 repetitions of the standard program, but...

31 July 2024 9,186 0 View

Does the first semicircle represent contact resistance, and what is the reason for its generation?

My research topic is the corrosion of gray cast iron in methanol. EIS measurements were conducted at open circuit potentials (Eoc) using a sinusoidal signal with the amplitude of 10 mV from 100...

05 June 2024 6,891 2 View

How to simulate plasma jet by COMSOL?

In COMSOL, how to use the gas concentration distribution results obtained by steady-state calculation as initial condition for plasma module for subsequent calculations? The commonly used data...

09 May 2024 7,335 0 View

How to analysis Mossbauer Spectroscopy data?

Scenario: I got two data files (α-Fe and Fe-containing samples), and the file names contain the max velocity value. Confusion: 1. How should I plot the X-axis? Is +/- velocity with points...

07 May 2024 3,244 0 View

How to extract bioactive compounds from fungal cultural filtrates...? Which of the techniques are best for the isolations...?

simply asking about the isolation of the pure compounds of fungal cultural filtrate as like the distillation of the essential oils..

06 May 2024 2,110 3 View

The failure for thiolated -Aptamer binding onto Gold surface?

Hello. I have try to immobilize the thoilated aptamer onto the gold surface such as Gold coated silicon wafer and the gold coated screen printed electrode. However, it is failed, after aptamer...

29 April 2024 4,054 1 View

What are the key differences between MMGBSA and MMPBSA in estimating free binding energy of a protein-ligand complex following Drug design study?

Please help to understand the aims and scopes of these two different techniques along with the possible computational cost that they render. Thanks.

25 April 2024 9,711 2 View

How much time does NCBI GenBank takes for public release of complete chloroplast genome sequence?

We have assembled a chloroplast genome of angiosperm and submitted the annotated assembly to NCBI GenBank. Within two-working days we got accession number for that submission. GenBank in their...

21 April 2024 9,974 0 View

The ring compounds or polymers with diameters greater than 15nm?

Are there any ring compounds or polymers with diameters greater than 15nm that are easy to synthesize or cheap to purchase?

21 April 2024 9,131 0 View

What type of insect species is this on Guava plant?

Although it looks like mealybugs but I hardly encountered such type of insect..doesn't looks like spiral mealybug too..could be scale insect like Orthezia..needs techinical advice..thanks

14 April 2024 4,019 5 View

Why might the impedance values for DI water and 0.1X PBS buffer solution exhibit a decreasing and increasing trend, respectively over time (HP 4194A)?

Hello everyone, I'm encountering an issue with my electrochemical impedance spectroscopy (EIS) measurements and would appreciate some insights. Experimental Setup: Electrodes: Gold interdigitated...

05 August 2024 3,783 2 View

Mossbauer spectroscopy Co0.6Mn0.4Fe2O4 MNPs?

Following curve related to Co0.6Mn0.4Fe2O4 Magnetic nanoparticles with extra phase a-Fe2O3. I will appreciate to help me to interpretation this spectroscopy, especially the blue line.

31 July 2024 9,140 2 View

How to calculate conductivity using Electrochemical Impedance Spectroscopy's Nyquist plot?

Hello everyone, I am new to this characterization but watching videos on youtube I have already plotted a Nyquist plot (Z' and -Z'') and already fitted models on my material using Zsim. But now I...

29 July 2024 1,376 0 View

Why semicircle of nyquist plot is not complete?

While I am doing HER, I noticed that nyquist plots of Electrochemical Impedance Spectroscopy (EIS) is not complete. Will it affect for the Linear Sweep Voltametry (LSV) data? However, I can found...

26 July 2024 7,542 4 View

What is single absorption ESR spectroscopy ?

In the context of Electron Spin Resonance (ESR) spectroscopy, under what conditions is an absorption spectrum considered to be a single absorption spectrum?

25 July 2024 2,325 1 View

Can we fit a gaussian Fit on a LIBS Peak ?

Though much literature suggests fitting a Voigt profile on a LIBS peak, is it also possible to fit a Gaussian profile on the LIBS peak? I have 204 spectra files, and I am building a pipeline for...

23 July 2024 6,127 1 View

What binder would be the best choice to modify glassy carbon electrode with a 2D Material like Graphene or MXene?

I am trying to drop cast 2D Materials on Glassy Carbon Electrode for Cyclic voltametry and EIS purpose. What would be best binders to use?

23 July 2024 5,776 2 View

What does negative readings in spectrophotometer denote. Was testing TSS content of bacterial cultures?

I was performing estimation of Total Soluble Sugar content in bacterial cultures by Anthrone method. Out of 9 samples, only one sample showed positive reading while others had a negative reading...

22 July 2024 9,576 4 View

How do you decide an optimal AC amplitude for non-faradaic electrochemical impedance spectroscopy?

I work with planar interdigitated electrodes (IDEs). The finger width and the spacing between the fingers are 5 micron. The surface of the IDEs is coated by a non-conductive polymer layer...

16 July 2024 5,031 1 View

Why is EIS important even if the cell is only run under DC conditions?

If impedance is an AC phenomenon, or if AC causes certain cell phenomena to become prominent at certain frequencies, why do we care about them? Under working conditions the cell will be...

14 July 2024 6,321 1 View