The ring compounds or polymers with diameters greater than 15nm?

22 April 2024 0 9K Report

Are there any ring compounds or polymers with diameters greater than 15nm that are easy to synthesize or cheap to purchase?

Badges
Science topic

More Yuan Yue's questions See All

Tissue homogenization in mouse with FastPrep-24™ 5G - is the D matrix system useful?

I need to lyse and homogenise mouse tissues. So far I have experimented with liver and lung tissue, using matrix D. The liver was completely lysed with 6 repetitions of the standard program, but...

31 July 2024 9,186 0 View

How does EDX or EDS equiped in SEM discriminate La and Cr in the circumstance of their characteristic X-ray energy dispersive peaks nearly identical?

Recently, we measured EDX/EDS of LaCrO3 crystals synthesized by hydrothermal method, and found that the characteristic energy for La and Cr are nearly the same for all of the noted energy levels....

02 July 2024 4,587 6 View

Why did the simulated load-displacement curve of beam keep increasing and didn't decrease (ABAQUS)?

Dear colleagues, I'm currently modelling a simple 4-point bending test of a concrete beam in Abaqus. However, the load-displacement curve was ascending (without final point), which didn't match...

29 June 2024 6,192 2 View

Does the first semicircle represent contact resistance, and what is the reason for its generation?

My research topic is the corrosion of gray cast iron in methanol. EIS measurements were conducted at open circuit potentials (Eoc) using a sinusoidal signal with the amplitude of 10 mV from 100...

05 June 2024 6,891 2 View

How to eliminate the periodic functions in Eq.3?

The equation in fig.1 can be transformed to the one in fig.2. Using ‘atan’, we can turn the periodic function ‘tan’,which is on the left of Eq.1, to the sum of ‘atan’ and l*π. However, for the...

14 May 2024 8,585 4 View

How to simulate plasma jet by COMSOL?

In COMSOL, how to use the gas concentration distribution results obtained by steady-state calculation as initial condition for plasma module for subsequent calculations? The commonly used data...

09 May 2024 7,335 0 View

How to analysis Mossbauer Spectroscopy data?

Scenario: I got two data files (α-Fe and Fe-containing samples), and the file names contain the max velocity value. Confusion: 1. How should I plot the X-axis? Is +/- velocity with points...

07 May 2024 3,244 0 View

Is it correct to call model 2 (Hayes Process) a double moderation model?

I am using PROCESS (model 2) to conduct moderation analysis with two moderators (moderator W is a categorical variable while moderator Z is a continuous variable). DV is predicted by X (IV), W, Z,...

07 May 2024 8,042 0 View

What are the recent applications of chitosan in the field of environmental photocatalysis?

What are the recent applications of chitosan in the field of environmental photocatalysis? Have you ever implemented chitosan based environmental photocatalysts

06 May 2024 3,736 0 View

How to extract bioactive compounds from fungal cultural filtrates...? Which of the techniques are best for the isolations...?

simply asking about the isolation of the pure compounds of fungal cultural filtrate as like the distillation of the essential oils..

06 May 2024 2,110 3 View

• What the possible Persistent Organic Pollutants and Heavy metals present in fluorspar, sediments, and water bodies around its mining area?

Approximate concentrations are require in compared with the WHO permissible limts

11 August 2024 2,723 1 View

Basis set and input instruction to calculate HOMO and LUMO using Orca for Imidazolium based organic salts?

Hey there, As a synthetic chemist delving into theoretical calculations for my imidazolium-based organic molecules, I would greatly appreciate any guidance on the appropriate input instructions...

09 August 2024 5,443 7 View

Separation of organic acids-HPLC?

Hello What should be done to separate and identify organic acids in HPC when their RetTime is the same?Like oxalic acid with Propanoic Acid.or acids that have a very close RetTime.

07 August 2024 8,782 3 View

Polymer wear calculation?

What is the method for analytically calculating the wear and service life of polymer-polymer sliding pairs?

04 August 2024 1,078 1 View

How to convert g/kg Humic acid dose to kg/ha?

I used humic acid at 0.044 g/kg soil in my pot experiment. But finally, I have to recommend kg/ha. Each pot's soil weight was 11 kg. What is the solution?

02 August 2024 7,185 6 View

How to improve peaks separation in HPLC?

Hi everyone, I'd like to better separate two close peaks coming from a bioconversion sample, I'm currently using a C18 KromaPhase 4,6mm Ø.I. SCHARLAU, particle size (µm): 10, pore size (Å): 100,...

30 July 2024 435 3 View

How to explain the different interaction between soluble and insoluble polymer in water?

Hello everyone, I am try to understand the differences interaction between insoluble and soluble polymers in water with metal ions and how theit charge density (of metal ions) affect the interaction.

29 July 2024 6,350 3 View

How to separate the stereoisomers compond in reaction mixture?

how to separate the organic reaction stereo isomers compounds are separate from the reaction mixture any simple methods are available

23 July 2024 8,025 4 View

I want to buy Hydrothermal Synthesis Autoclave from any European company. Can anyone suggest any company inside Europe?

Thanks

22 July 2024 1,142 3 View

Hi dear researchers, do you suggest the best and shortest path for chemical synthesis and green synthesis of magnetite(Fe3O4)?

Suggest the best and shortest route for the chemical synthesis and and green synthesis of magnetite(Fe3O4) The chemical synthesis should contain the least dangerous chemicals along with full...

21 July 2024 2,476 2 View