It is possible to read the acceleration values from the microcontroller above? I have been struggling as the datasheet didn't explain this or because I am a novice
If you have selected the microconroller and wish to interface an accelerometer to this microcontroller, you have to understand:
a) What is the output of the accelerometer? Does it need an amplification? Does it need noise removal? Are opamps and filters present in the microcontroller for this purpose? If not, you will have to add those.
b) Should I use interrupts or polling? Polling is easy, but will dissipate a lot of power.
c) Will you connect the output of the accelerometer to an input port? How do you configure the I/O ports to input/output? How will you enable the interrupts?
Most microcontroller vendors will provide sample code that you can use.
Best of luck!
Yes, you can interface CN0533 or ADXL1004 with ESP32. The ESP32 has a variety of communication interfaces, including I2C, SPI, UART, and more, so you should be able to connect the two devices. The process will depend on the specific communication protocol you are using. For example, if you are using I2C, you will need to configure the ESP32's I2C pins, set up the I2C bus, and then write code to read and write data over the bus.
- Badges
- Science topic