Cl and azide linked to n-hydroxyphthalimide
:) Thank you so much. Since I couldn't find any solution I carried out the water extraction and NMR showed peaks for Cl product. So I'm going to add some azide again. Thank you for your advice.
currently I am trying to model and engine system where i want to simulate it using Cruise M and then to test it with different fuels to observe the behavior of said engine. I am having issues with...
06 April 2024 124 1 View
For research purposes, I need to determine how citizens perceive space through user experience; to do so, I need to identify different emotions using Heart Rate Variability Signals or ECG data. I...
04 January 2024 7,001 4 View
Routine isolation and identification of aetiological agents of Superficial Mycoses is of utmost importance in a tropical, humid country densely populated compared with the available land area....
27 September 2023 3,456 14 View
Most of the leaves reflect mid and far infrared radiation. But there may be few types that their outer layer is transparent to mid or far infrared.
16 August 2023 2,891 1 View
There are many white coatings or solar coatings available commercially, but is there a radiative cooling paint available commercially?
09 June 2023 3,645 3 View
By genetically modifying we can alter some properties of plants. But can we modify the biophysical, optical or thermal properties of leaves?
30 May 2023 1,035 3 View
HI all, I need to access revised (KMPAI) and use it for my dissertation for my MSc. Any advice on how to go about doing that? I've messaged Dr. Kenny already.
14 January 2023 9,482 0 View
I need to analyze XRD data to discuss the crystal defects in zeolites which I have synthesized in different conditions. Can I use stacking fault value, microstrain, and dislocation density for...
09 January 2023 8,228 3 View
Hi Everyone, Could you please suggest to me how to obtain an empirical equation that shows the relationship between input and output variables in ANN? I used the following in MATLAB, and I am...
28 December 2022 9,110 3 View
I'm trying to quantify elements using XPS narrow scans. I need to get the standard deviation of At% too. I understand that the CasaXPS gives us the standard deviation of At% when quantified using...
29 November 2022 9,606 3 View
I need to do some experiment with it in liquid form.
07 August 2024 613 3 View
I work on MCF7 cell cell for anticaner purpose and I wa to do drug preperation the drug ( secondary metabolites extracted from Aspergillus) My question which solvent is better with these secodary...
03 August 2024 4,725 2 View
I imagine the battery drives the graphite into a carbocation, then chloride is oxidized to donate the electron to the carbocation, but what pushes the lost electrons of chloride to be shared...
03 August 2024 5,384 0 View
Hello everyone, I need to dissolve stigmasterol for an animal experiment, but it hasn't dissolved in either DMSO or vegetable oil. Can anyone recommend the best solvent for stigmasterol?
01 August 2024 7,504 2 View
Hello everyone, A collaborator sent us his protocol in order to be able to use his immunohistochemistry kits. But one step contains PBS + 0.3% H2O2 + 0.1% sodium azide. Knowing the dangerousness...
23 July 2024 6,314 3 View
Why methanol and sulphuric acid, used in the analysis of polyhydroxyalkanoates (PHA) methyl esters by GC-MS? Additionally, why do we typically use non-polar solvents in GC-MS?
22 July 2024 1,210 2 View
Is it the best optimization ratio based on experiments?
22 July 2024 8,170 0 View
If you don't understand my question let me know
21 July 2024 563 1 View
I used several solvents and measured the absorbency and determined the total phenolic content, but the results were similar after dropping them on the titration curve; What is the reason, please help
17 July 2024 5,151 5 View
Hello everyone, I am facing a consistent issue in my NMR spectra with an unwanted peak appearing at 1.25 ppm. This peak seems to vary with the amount of sample: it becomes more pronounced with...
15 July 2024 9,065 4 View