I did a Western Blot yesterday but, my band doesn't exist!
I think my antibody dilution is wrong... I used 1:10,000 for anti-ERG
What dilution should I try this time?
Hi Marian
It depends on which antibody you are using...
What does the datasheet of the antibody says? (For example abcam suggests for WB of ERG between 1:1000 and 1:10000 - if this is your case I would go to the 1:1000 and see what happens)
Good luck
05 June 2018 7,188 2 View
Hi everybody, I looking for a very good method to isolate exosomes from serum and urine. I will use these exosomes from study microRNAs. I'm never have worked with exosomes before so, I don't have...
04 May 2018 5,102 4 View
31 December 2017 6,065 3 View
I'm going to do a wound healing assay with a cytosine arabinoside like proliferation inhibitor, but I don't know if I have to administrate this inhibitor every 24 hours o what time is the best....
11 December 2017 901 2 View
01 February 2017 837 3 View
01 February 2017 8,566 4 View
I have a protein with a 10xHis-MBP tag on the N-terminus. I'm fairly certain I am expressing my protein, but I'm not getting a signal on my western blot. Is there a possibility that the 10xHis tag...
25 February 2021 8,404 3 View
I'm currently working having problem with the concentration for recombinant protein use in western blot, the one been used is Recombinant Human CD19 Fc Chimera Protein-rndsystem which does not...
24 February 2021 8,514 3 View
Increasingly, more articles are being retracted because of duplicate or otherwise dubious Western blots. Consequently, journals are asking for original Western blots and authentication of...
23 February 2021 8,609 3 View
Hi Everyone, I am a bigginer in western blotting and I am trying to use it for validation of my proteomics data. I have: two regulated proteins with molecular mass of 40 and 73 kDa one control...
23 February 2021 6,671 4 View
I need help using the equation C1V1=C2V2 figuring out how much antibody to add to use for a western blot. The stock was origianlly 3.45 ng/ul but diluted 1:10 so now its 0.345 ng/ul. I need to run...
22 February 2021 9,901 3 View
I run western blot on HCT-116 cell lines, I got actin band like in the attached picture. The band size is not same. Can anyone help me explain this situation and how to overcome? Thank you your...
22 February 2021 6,937 3 View
I ran a western blot using 12% gel and probing for ERK/pERK (cell signaling antibodies). The green is total ERK, the Red is supposed to be phospho-ERK. I see 2 bands below the total ERK that...
22 February 2021 1,777 3 View
Hello, I am performing a western blot of my SARS-CoV-2 Spike-pseudotyped lentiviral particles. I denature my virus by adding concentrated virus to 2X Laemmli buffer at 1:1, then boiling for...
17 February 2021 4,844 4 View
Hi, so basically... I am trying to mimic a clinically observed condition wherein a frame-shift mutation happens only at one allele of the patients, giving rise to a truncated variant which evades...
17 February 2021 1,130 6 View
I accidentally rinsed with methanol after adding my primary antibody to my membrane. I noticed after ~10 seconds and immediately replaced it with PBST (3x15 min washes). Will my antibody signal be...
12 February 2021 5,824 3 View