i get this warning many times when i run the Job : There is zero MOMENT everywhere in the model based on the default criterion. please check the value of the average MOMENT is small enough to be treated as Zero. if not, please use the solution controls to reset the criterion for Zero MOMENT
i am trying to indent a box using an analytical rigid Body
so if anyone knows how i can eliminate this error, please help
Usually, this is o.k. (it is just ) - if you indent a box, there will probably be no rigid body rotation so a zero moment should be expected. If your model is 2D (or approximately so). zero moments are totally normal.
Usually, this is o.k. (it is just ) - if you indent a box, there will probably be no rigid body rotation so a zero moment should be expected. If your model is 2D (or approximately so). zero moments are totally normal.
May be you considered nonlinear geometry in your Time history analysis after initial step. Turn it off so the problem shall be solved.
- Badges
- Science topic