How to model and simulate the behavior of nanoparticles in an evaporating sessile liquid droplet. The objective is to simulate and to know the behavior of nanoparticles at the end of evaporation (deposition)
See attached articles
Thank you Adeyinka Aina for the papers
A bunch of flower for everybody. I would like to ask about the list of journals which we can publish our paper for free. Thanks in advance. Sincerely Walid
25 February 2021 9,790 3 View
Hi there! My lab has been brought an array of C-4 I cell line. The cells did not succeed in attaching to the bottom of the flask and remained floating in the media. Although we followed the...
04 February 2021 10,018 5 View
hi everyone, I have developed a simulation of a roundabout with a fixed time regulation, the lines of traffic lights in the roundabout are for vehicle storage. my question is: when we regulate by...
16 December 2020 1,923 3 View
Hello everyone, hope you are doing well. I made a simple traffic actuated control logic using VisVAP Stage 1 is for Vehicle Stage 2 is for Ped the compilation in VisVap run with success, but...
07 December 2020 553 3 View
24 October 2020 9,262 7 View
There are many universities that have excellent scholarship opportunities for international students.
21 September 2020 3,391 4 View
good morning, I found some difficulties to identify a compound extracted from a medicinal plant and analyzed using LC-MS/MS. I can't find the compound name in databases peaks (m/z) and intensity...
15 July 2020 5,669 3 View
According to the characteristics of each
21 March 2020 307 8 View
Our project objective is to investigate the genetic diversity of Palestinian date palm, cultivars. 6 primers were ordered, these primers were designed specifically for NGS analysis. DNA was...
06 February 2020 695 2 View
Two 12 V, 250 Ah batteries are connected in series and then connected in parallel with two more series-connected batteries of the same type. What is the total output voltage and Ah rating of the...
02 February 2020 1,821 3 View
Need to image mesoporous silica nanoparticles using the TEM. Also, need high resolution TEM images to see the mesoporous structure. Kindly suggest what kind of grids to use. Thanks, Shatadru
02 March 2021 1,787 2 View
Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...
01 March 2021 9,332 6 View
[Synthesizing Cu nanoparticles without using chemical reductants]
01 March 2021 8,359 1 View
In the stabilization of AgNPs are vital in current research interest. However, some of the 2D nano-materials like graphene oxide, MoS2, etc... previously used to stabilize it. But still they shown...
01 March 2021 2,207 3 View
I am a little confuse with the mechanism of solid lipid nanoparticles (SLNs). The main point of encapsulating drugs into SLNs is because some drugs have low solubility in water. Therefore, SLNs...
01 March 2021 3,703 3 View
I try to check the uv-vis absorption of Indium nanoparticle. Now I am measuring in solution, can I measure it in the form of a film?
01 March 2021 930 3 View
I want to cool Natural Gas from 195 Kelvin to 138 Klevin in a heat exchanger by using liquid nitrogen as the coolant medium. When entering the heat exchanger, the liquid nitrogen will have a...
01 March 2021 6,450 5 View
The resultant solid was partitioned three times with 250 ml of petroleum ether (40-60/c) to remove any fatty material and evaporated to dryness.
28 February 2021 9,464 2 View
How would define the "good" and "poor" distribution of particles within the matrix. Is there a quantitative solution to assess the distribution of the particles, which then having denotation of...
28 February 2021 7,397 8 View
Favourable conditions of base pressure, rate of deposition. Also, by which characterisation technique to be used to verify the thickness of the deposited film.
28 February 2021 3,640 3 View