I have an issue when running ANSYS to get the results, sometimes fails because of the applied load. How can I know there is a problem before applying the solution?
Dear ali,
Can you please elaborate which type of loads applied and which kind of analysis you are trying to run in ANSYS? As there should be very specific answer for your question depending upon these .....
Hi Satyen,
Thank you for replying. I meant applying loads in the structural beam, specifically applying pressure on half circle from two side lower left and lower right.
Thanks.
if u are working on ANSYS apdl then you should check list of applied loads and boundary conditions and for workbench it shows a tick mark on applied actions if action is correct.
Hi Piyush, thank you for replying. I see, currently I'm working on ANSYS apdl so I will check the loads as you suggested. Thank you.
Hai friends,
Does force on nodes and pressure on line gives the same stress results? Is there any exceptions ?
- Badges
- Science topic