I want to simulate a synthetic jet actuator (SJA) in ansys fluent 13. This SJA will be used to control flow over a NACA 0015 wing. I want to use a loudspeaker as SJA for convenience. As far I know, to simulate SJA, Dynamic Meshing has to be used in Fluent.
I have done such a simulation on a transonic compressor blade. I can provide you with a publication of mine if you wish. I can send it to you privately since is copyrighted material.
I have done such a simulation on a transonic compressor blade. I can provide you with a publication of mine if you wish. I can send it to you privately since is copyrighted material.
You can have a look at the following paper: Jain, M., Puranik, B.P., and Agrawal, A., "A numerical investigation of effects of cavity and orifice parameters on the characteristics of a synthetic jet flow," Sensors and Actuators A, Vol. 165, pp. 351-366, 2011.
I also want to simulate a synthetic jet actuator (SJA) in ansys fluent 15. So far, my meshing always failed. It will be very helpful to have some suggestion from you sir.
- Badges
- Science topic