I want to create a loft surface by connecting the curves shown in the attached figure. Is there any way to do this in matlab? If not, which software would be best suited for this job?
Thanks for your answer Bruno. But, it's required to have the axes in the figure. I can use Solidworks as you suggested in that case it would be a surface part. Which cannot be used in any scientific article. Thanks again.
For the axis, you can add them or just import the object converted to a mesh in Meshlab and show the axis.
As for the the part where Solidworks, or other commercial software, could not be used for a scientific article, I'm not sure I understand what you mean? What makes Matlab or Mathematica works and not other softwares?
Oh. Sorry if I was not clear. Yeah. My only concern was the axes. I meant, if I have the part only without any axes that wouldn't make too much sense in a paper. I'm try your mesh idea right now. Thanks for the great tip.