Using the setup from the attached image, the following error occurs:

Setup:

Geometry>Mesh>Mechanical APDL

Trying to open the analysis as MAPDL.

When I try to open MAPDL it just flashes a black command window and doesnt open.

I went into the folders where the .wbpj is saved and found the error file (file.err).

It had this error in it:

*** ERROR *** CP = 0.266 TIME= 11:12:12

The /MENU command is either not available for this version of ANSYS or

the appropriate product was not selected for this session.

Contact your ANSYS support person for more information.

/COM,ANSYS RELEASE Release 19.2 BUILD 19.2 UP20180808 11:12:19

/COM,ANSYS RELEASE Release 19.2 BUILD 19.2 UP20180808 11:13:36

More Thomas Mikolajewski's questions See All
Similar questions and discussions