hello
i am running 2D CFD simulation for wind around a square section and when i open the results (CFD-post) i get this error message "
WARNING STREAMLINE:Streamline 1 Could not locate Domain List entry surface_body. ERROR Empty domain list found in Domain List parameter" does anybody know what does that mean?
are you defining your streamlines at a no slip surface? If so, there shouldn't be streamlines on that surface.
First of all iit is warning not error which means that you could be able to produce any other results.
Second, you may defined the stream lines at a surface body. If you have defined Named Selection called surface_body then check where it is defined. It seems that it is a surface (where no slip boundary condition is defined as Rafael Said) remove it and everything will be fine.
Best regards
Mohamed
- Badges
- Science topic
- Similar topics
- Biological Science
- Kinesiology
- Running