below picture is my analysis model. because at corner part, there are many studs inserted, so such partition is needed. however at the orange color part, at first, it is possible to make a sweep mesh, but because of the influence of the previous partitions, it is difficult to make a mesh like picture 2. After do partition After the partition in the corner, a sketch like Picture 2 appeared in the orange part. And it is impossible to delete it using remove redendant entities. how to solve it,, ?
Dear Lee,
If the number of partitions, which are needed, is too much (as the number of studs are). That would be time consuming to do it for each stud, also the corrections in mesh or partition (if needed) become difficult.
In such cases that would be probably better to make a script (python code) - get a "Macro" from partition command in Abaqus, then make it parametric and run the code for partitioning, in such way edits become much more easier.
Depends on the place you want to partition, you need just to change sum values in your macro instead of do the partition command again and again. Generally for repetitive commands, it's better to use programming rather than UI(user interface). ( File - Macro Manager - Create Macro)
Hope it helps
- Badges
- Science topic
- Similar topics
- Biological Science
- Bioecology
- Systems Ecology
- Landscape Ecology
- Connectivity