I have been working on Incremental Forming, Trying to simulate the process in Abaqus. getting this Error :
A BOUNDARY CONDITION HAS BEEN SPECIFIED ON NODE SET ASSEMBLY_SET-19 BUT THIS NODE SET IS NOT ACTIVE IN THE MODEL.
This means exactly what it says: You have defined a boundary condition, but (possibly because you edited your part) this is not active in the model. If you work with CAE, go to the bc manager and click on each bc to try and edit it. If the region is not active, a warning will pop up, you can then correct.
NODE SET ASSEMBLY_SET-13 HAS NO MEMBERS AND WILL BE IGNORED.
NODES DEFINED IN THIS SET MAY HAVE BEEN DELETED BECAUSE THEY WERE
NOT CONNECTED TO ANY ELEMENTS.
.dat file is showing this Warning.
Sir, I have tried to edit the bc but still it is showing same error
So use the set manager (somewhere in the tools) to find out where you defined this set and why it is not meshed.
Sir I have edited both set and boundary conditions but still same error is arising.
- Badges
- Science topic