Hello everyone,
I am planning to do some regression analysis on the Envi-met simulation results, and for this, I need an excel file containing air temperature for every 3D point of the model (for each x, y, and z). Should I place a receptor on all the cells or is there a quicker and perhaps easier way to achieve this?
Thanks
Who knows? Try it . If it doesn't work try something else. Research is like this. Best wishes, David Booth
Dear dr. monsefi
To this end, we can extract data of x-y section cuts for each level and then gather into one spread sheet.
Another way is extract data by writing script in Leonardo.
or use of envi-met component in geasshopper-ladybug.
Regards
Hi,
simply enable NetCDF outputs and you are able to load that output file in R etc. by using existing libraries.
Best,
Tim
Hi,
I think you have two options the first one is to impose receptors in different locations on your site.
The second one is to take a section in your site that you are imagining is important in your simulation
and you can get the results from the LEORANDO map.
Good Luck
- Badges
- Science topic
- Similar topics
- Computer Communications (Networks)
- Simulators