Hard, amorphous, brittle, inorganic, usually transparent, polymerous silicate of basic oxides, usually potassium or sodium. It is used in the form... | Contact experts in Glass to get answers
1,087 views 1,942 posts
Questions related to Glass
I am not able to understand the reason behind non-stoichiometric behavior shown by the thin films deposited with reactive sputter deposition technique.
20 July 2022 2,188 14 View
i am doing metal chelation assay for that i used iron (II) Chloride tetrahydrate and ferrozine. i take 0.1 ml iron (II) chloride tetrahydrate in test tube and added 0.2ml ferrozine as a control...
19 July 2022 3,276 0 View
I need to dry a sample of allumina. What is the minimum temperature for drying allumina without vacuum? Is it enough 250°C for 4 hours? Is it important the allotropic form (alpha or...
18 July 2022 4,020 8 View
Hello, How can I silanize (by adding a coupling agent) Aluminium Oxide (Al2O3)? E.g. epoxy, amine, vinyl type silane. How can I do this on lab scale? Is there a way/technique (e.g. microscopic)...
12 July 2022 9,313 2 View
CIF file for use in EBSD analysis. Thanks in advance for those who will answer.
06 July 2022 3,440 1 View
Hi, I wold like to know if is there any control scheme that consider a torque feedback (maybe thru an torque observer) in a FOC. In the schemes that I have is aways the speed error signal that...
05 July 2022 5,897 0 View
Dear all, I am searching for some information concerning the dynamics of TGN-020, an aquaporin 4 channel blocker. Has anyone worked with it? Do you have any information on the time it takes for...
04 July 2022 2,773 0 View
I have tried using the software VAMPIRE to simulate curie temperature, but I am not being able to do it correctly for some reason. Can anyone please tell me how to do it just by using Python or...
02 July 2022 3,877 0 View
Why do I need to provide higher strains for my emulsion samples with the lowest storage moduli to access yielding respectively leaving the LVR in comparison to the samples with much higher storage...
01 July 2022 3,964 0 View
When I try to calculate the phonon dispersion of a 2D material with the CASTEP module of Materials Studio, the calculation stops with 'Error: magres_apply_green_function_s2: not converged' Can...
27 June 2022 5,287 1 View
My ELISA plate has 12 replicates of each sample in a row, and it shows an OD gradient. for example A1 (100mIU) if say has OD of 3.9 and gradient down to 2.9 OD at A12. I addressed different...
23 June 2022 9,432 1 View
Consider the attached figure. The red point is the transmitter and the blue one is the receiver on the same z-plane. There are two paths with equal distance and angle of incidence. The pathloss is...
22 June 2022 9,057 0 View
I developed a high power thulium fiber linear cavity with that can generate only 25% efficiency (FBG 1950 nm high reflection and low reflection equipped). Based from literature review maximum...
21 June 2022 9,142 3 View
The introduced mass and strain fluctuations in the lattice after doping should impede the phonon propagation and decrease the lattice thermal conductivity. Why the lattice thermal conductivity is...
20 June 2022 8,931 11 View
I have synthesized a seven amino acid sequence having a C-terminal amide Phe-Aib-Leu-Ala-Aib-Leu-Phe-NH2 by Rink amide resin. I have got the mass spectrometry done and somehow the peptide didn't...
20 June 2022 1,739 0 View
I am working on a lithography process using spr220-7 photoresist. I want to know the etching method of spr220-7 photoresist. I want to have specific dosage parameters and etching rate. In...
14 June 2022 3,463 2 View
From the temperature dependent magnetization curve (M-T curve), how to measure/ find/ calculate Kondo temperature ?
08 June 2022 8,132 1 View
A link for purchase would be helpful!
07 June 2022 7,748 3 View
Hi, the concentration of aqueous solution of bisphenol A can be measured by using UV-VIS?
31 May 2022 9,835 0 View
I can't find the amino acid tyrosine, does it have another amino acid that can be replaced?
30 May 2022 7,907 5 View
Hi all, I am trying to access the shift in molecular weight of a sulfated polysaccharide before and after hydrolysis. Nothing has worked well so far with my 2 methods: 1. Loading the products...
27 May 2022 2,025 0 View
How can I access information about the effect of friction dampers (Coulomb dry friction) on the dynamic equation of motion? Also the effects of this type of damping on the energy balance equation.
26 May 2022 1,566 2 View
I use cameras (with Si and InGaAs sensors) to measure intensity profile of laser beams. I want the dynamic range (DR) to be as high as possible, as to see low intensity part of laser beam profile....
26 May 2022 8,113 0 View
I am using CO2 laser with beam diameter 0.3mm and max power 100W with continuous and focused beam. for example I want to perform my experiment with 6000mm/sec scanning speed and 60W power with...
18 May 2022 3,964 2 View