MC12059 ChungKarYee

11 Questions 8 Answers 0 Followers

Questions related from MC12059 ChungKarYee

How to calculate the flow rate of water inside the piping using pressure?

Pressure is 2 bar and the pipe diameter is 2 inches

12 December 2017 6,911 5 View

What causes a magnetic contactor burnt?

Good day everyone, Is anyone knows why a contactor burnt ? It is a 220V and 50Hz magnetic contactor which connected with the oil circulation pump motor. thank you.

02 February 2017 2,984 0 View

What is the application for paper gasket?

Good day everyone! Is it suitable to use paper gasket for the thermal oil valve?

12 December 2016 5,530 1 View

Does anyone know in what condition we need to tune the sensitivity adjuster of the sensor? Is it based on the size/diameter of the target?

Good day everyone, Sensor Model: Omron E3Z-T61 photoelectric sensor. The attachment below is the manual and image of the sensor. Thank you in advance.

11 November 2016 7,875 2 View

What is VPN?

I have learned from website which said that I can change my IP address through VPN but I don't understand what is it and also is it safe ?

11 November 2016 8,357 2 View

Hi, what to do if error message always appear when running simulation using ANSYS fluent?

Currently running simulation using ANSYS fluent with time step size = 0.01 and number of time steps = 360000. (In reality i have to carry out the process in 1 hour, so 360000 times 0.01 equal...

05 May 2016 4,204 3 View

Hi, anyone know how to restore the license file to default format?

Hi, i not carefully open the license file in notepad and i can't find a way to restore it into default format. I have try use the 'regedit' method but still the icon still is in notepad form. Does...

03 March 2016 4,546 0 View

Anyone know how to create 2D using Autodesk Simulation CFD 2015?

Hi good day to everyone. Recently i'm trying to construct a 2D model using Autodesk Simulation CFD but i failed so i wish to get some guidelines from you all on how to create the 2D model in...

03 March 2016 5,175 5 View

Anyone know how much power(watt) of electrical heater that will be required to generate heat which can achieve 400 degree Celsius?

Hi, currently i try to figure out what kind of heat sources that can be used to heat the plastic to 400 degree Celsius and the amount of power(watt) that needed to consume in order to reach and...

02 February 2016 2,947 4 View

Hi, anyone know what is the factor of safety of mild steel?

AISI 1018 mild/low carbon steel has excellent weldability and produces a uniform and harder case and it is considered as the best steel for carburized parts. AISI 1018 mild/low carbon steel offers...

11 November 2015 7,776 3 View

What kind of bearing is suitable to support applied load of 1000 lbs ? Is there any other factors that we need to consider when selecting a bearing?

Hi everyone, the provided link is some information related to the bearing.

10 October 2015 9,581 7 View