11 Questions 14 Answers 0 Followers
Questions related from K Vasudev Reddy
To measure s-parameters input port impedance should be matched with output impedance i.e 50 ohms. The circuit what I have implemented is having 190 ohms at output side. So I am getting less power...
27 June 2016 4,938 3 View
The circuit in Fig. has two signal paths: one is M1—M3—Vo2, the other is M2—M4—Vo1. And the two paths have the same voltage gain, but impedances are different. To measure S-parameters I have...
22 June 2016 9,072 7 View
I have implemented single to differential LNA , which is having output impedance equal to 2k ohm. Now to measure S-parameters, both input and output should have same 50 ohm termination. To convert...
29 February 2016 7,051 0 View
I have used transformer(even I have tried with ideal_balun available in analog library of Cadence) at the differential output and terminated with a port . I have measured output impedance of the...
22 February 2016 8,370 3 View
I am trying to sketch the layout of simple RLC band-pass filter in cadence. I am getting DRC error as "minimum overlap of IND to inductor layer is 10um" and I am also confusing that which material...
17 February 2016 8,702 2 View
I have connected a current source with 1A across an inductor and then I have observed AC response. It is oscillating at some frequency, but the thing is quality factor is not matching in the...
02 February 2016 2,044 1 View
Low Noise Amplifier, IDCS topology
26 November 2015 4,501 8 View
differential amplifier: Can anybody tell me how to set the common mode voltage in single to differential output amplifier?
18 November 2015 1,955 8 View
Does input-blocking capacitor affect the performance of impedance matching in inductively degenerated common source LNA?
16 October 2015 7,658 4 View
process parameters
22 July 2015 3,770 9 View
Specifications(NF,power dissipation, gain,IIP3 and etc..) of LNA and Mixer which is used for Medical radio communication
11 July 2015 2,107 5 View
