14 Questions 25 Answers 0 Followers
Questions related from Jonnala Subba Reddy
What is the influence of literature review for any journal paper? How do acess the quality of the paper based on Literature Review?
04 April 2019 3,495 4 View
Is it acceptable to write a paper without any reference? If so, will it be accepted? Can we write one page journal paper? To the point discussion would be possible or not? What are the...
11 November 2018 9,642 1 View
How far the research is being utilized for social cause? Is research given more importance than it is supposed to be given? How far these research papers, articles, letters etc. influence the...
05 May 2018 4,641 9 View
The experimental data is the necessity in analyzing our responses w.r.to different influencing parameters. But it is observed, in recent past, most of the researchers are publishing graphs and...
05 May 2018 6,773 8 View
What is the correctness of SEM, TEM and EDX analysis? What is the percentage of error? How do you calibrate the machine? I have got some data from the internet source. I request suggestions from...
05 May 2018 2,626 5 View
The plasma zone is the cause for removing the material from the work piece as well as from the electrode. What could be the temperature range of plasma during Electro Discharge Machining (EDM)?...
05 May 2018 6,261 1 View
Is there any good coupling interfaces available for ANSYS (FEM) and Electro Discharge Machining (EDM)? The heat transfer rate across the plasma zone, the temperature distribution along the...
05 May 2018 7,761 3 View
The mental trap or struck in between while doing the research work or writing a journal paper occur often in our life. We often get confused how many papers should be referred for writing a paper....
05 May 2018 4,621 3 View
Is it good to write the "Conclusions" section lengthy or precise in a journal paper? Kindly suggest.
05 May 2018 7,316 17 View
What are the general trends in Electrical Discharge Machining Process for MRR, TWR, SR, other responses with Current, T on, T off, Servo Voltage etc? For different materials like Al, Al alloys,...
05 May 2018 6,498 2 View
As the depth of cut increases in EDM process, the over cut on the material also increases because the spark is generated round the electrode. What precautions should be considered in designing the...
05 May 2018 4,429 2 View
Can you please suggest the text book or journal paper(s) of how to solve two dimensional partial differential equation with four boundary conditions and two initial conditions? The applications...
05 May 2018 844 3 View
What percentage of error will the assumptions carry in analyzing temperature distribution in Electro DIscharge Machining (EDM) Process? The assumptions will simplify the model. How do we calculate...
04 April 2018 350 0 View
Sir, Is it possible to find the average temperature of plasma experimentally in EDM Process? Can we find the temperature distribution across the workpiece and tool material for single spark and...
03 March 2018 2,208 8 View