Franco Concli

13 Questions 353 Answers 0 Followers

Questions related from Franco Concli

Who has experience with Ansol Transmission 3D?

Has someone experience on the computational performances of this software with respect to general purpose FEM software? Franco

04 April 2018 5,697 0 View

Is possible to simulate wave propagation in solids with Code-Aster?

Is Code-Aster capable to simulate transient lamb wave propagation? Franco

01 January 2018 1,757 3 View

Best OpenSource FEM?

Dear all, which is the best open-source / free FEM software? I'm using Code-Aster and I'm pretty satisfied... but are there alternatives?

12 December 2017 3,115 0 View

Non-Newtonian modeling of fresh concrete: parameters?

Can anyone please give me some reference to find the non-Newtonian model parameters for simulating fresh concrete or mud... Regards Franco

11 November 2016 4,567 2 View

Best free FEM software?

Dear all, which are the most powerfull FEM free available softwares for structural simulation analysis? Best regards Franco

08 August 2016 862 1 View

Available dynamic modeling softwares?

Which are the best available free dynamic analysis softwares for multi-body simulations? Regards Franco

02 February 2016 9,197 3 View

How can I calculate radial ball-bearing stiffness?

How can I calculate the radial stiffness of ball-bearing? I have found this formulae k=b*d+c where d: diameter b=1300 for ball bearing c=62500 for ball bearing A 6008 bearing has therefore a...

02 February 2016 7,175 4 View

Frequency response scilab?

Dear all, can someone give me some information about how to perform a frequency response analysis of a multi-dof system. Regards Franco

01 January 2016 1,102 1 View

Which is the best way to perform EHL simulations?

Dear all, which is the best way to perform EHL simulations? Is there some already developed free too alvailabe? Franco

08 August 2015 5,085 4 View

How should I set the sixDoFRigidBodyMotionCoeffs in OpenFOAM in order to have a proper mesh deformation?

Dear all, I need help in setting up the dynamicMeshDict for pimpleDyMFoam using sixDoF. Actually I have 2 concentric cylinders (2d) representing a shaft and a hole (journal bearing). On the...

11 November 2014 5,677 3 View

Bearing seminar by Schaeffler @ UNIBZ 24th Jan 2019

The seminar is free. For further information write an email to [email protected]

01 January 1970 1,633 0 View

Someone interested in a FEM course with open-source software Code_Aster??

Are interested in a course with Code_Aster? Unibz is organizing a 3-day course in October 2019. https://www.unibz.it/en/events/132491-engineering-simulations-with-open-source-codes

01 January 1970 3,631 4 View

Code_Aster for FEM simulations?

Dear community, I would like to inform you about a FEM course that will take place in Bolzano (Italy) this October. More informations are available...

01 January 1970 4,091 2 View