It is a general question. Not specific to any specific alloy
Do I need any sort of permission from open access journal where I published my paper? I want to re-use a Fig. Will there be any negative impacts of reusing data/Fig from published work?
11 December 2018 1,850 3 View
It is understood that high melting point elements (B, Zr, Nb, Ta, Hf etc) reduce the grain size mainly because they form solidification centers during cooling. However sometimes low melting point...
11 December 2018 1,185 0 View
The grain size below 250 nm in NdFeB is considered single domain. What is or should be the size of Fe-Co rich phase in alnico alloys which could be considered as single domain? P. S: Many papers...
09 October 2018 2,174 0 View
Is there any data available which shows the publications of Noble laureates---the publications which lead to the prize? Were they mostly published in high impact factor journals like Nature,...
09 October 2018 6,348 3 View
Example: If Nd atom (or say a thin layer of Nd atoms) is place between two Fe atoms, will there be exchange coupling or decoupling between the two Fe atoms? How about the interaction of Fe-Nd, is...
08 September 2018 8,274 1 View
How nano particles of Ce2Fe14B phase will interact with Nd2Fe14B, phase for example?
08 September 2018 6,940 3 View
This is a general question.
05 June 2018 2,308 3 View
Require for Rietveld refinement in XRD.
08 August 2024 3,080 2 View
Hello dear colleagues, We have prepared a manuscript on NiTi-based alloys and are seeking a second opinion on our current TEM results. If you are a Ph.D. holder with experience in TEM and have...
07 August 2024 9,563 0 View
During low-temperature testing, new diffraction peaks that appear could be indicative of several phenomena. In one of our tests, we observed notable new peaks around 40° and 45° in a specific...
06 August 2024 726 3 View
I want to refine one XRD peak of my in-situ xrd but the background is never working good which ultimately fails the refinement. How to refine and adjust the background using GSAS-II
05 August 2024 5,291 2 View
How to calculate the molar proportions of the oxides from the XRF analyses?
02 August 2024 2,565 2 View
I fabricated Ti3C2Tx using concentrated HF 40%, I plot an XRD as attached image below.. please let to know if I obtained it or not.
02 August 2024 6,789 4 View
How select composition for ods-high entropy alloys?
31 July 2024 2,795 1 View
What information we can get from PXRD analysis other than from SCXRD analysis of a crystal ?
30 July 2024 6,261 4 View
I will be doing an XRD on a sample which is powdered in natured and is a hydrogenated compound. I would like to know how we can understand the individual components and components by using the...
28 July 2024 4,548 2 View
Any suggestions with respect to etchant composition and holding time?
27 July 2024 6,924 2 View