Does pcDNA3.1 vector not work for HEK293T cells?
https://www.researchgate.net/post/Why-there-is-low-protein-expression-efficiency-in-HEK-293F-cells
https://www.researchgate.net/post/How-can-I-make-a-stable-HEK293-cell-line-using-pcDNA31
Those discuss topics that may be helpful. Good luck.
Dear Shin Murakami,
Thank you very much for sharing the important links.
Best wishes
Puspita
I have design a 6GHz antenna for wifi.The feed line width is 2mm and there are 2 parasitic elements beside this feed line with 1 mm gap.Is there any problem at the time of febrication?
04 February 2021 9,241 3 View
I have been trying to make an even PEDOT: PSS (PH1000) film with the doctor blade technique (tape casting) with varying results. I have been using a silicon substrate that's treated with piranha...
01 February 2021 8,506 5 View
Seeking recent experiences in the development and deployment of low-cost soil moisture sensors (ideally under $50/sensor) connected to arduino-based dataloggers. What is the longetivity of the...
19 January 2021 6,256 2 View
I would like to develop a method for analysis of many organic acids in the same time. how to separate the chromatographic peaks of each one?
20 December 2020 8,399 3 View
I have a data set of 771 sample size. But some of the variables (laboratory findings like ALT, AST, creatinie level) have more than 50% missing values. Should I drop those? But I think those...
13 December 2020 4,847 3 View
We are finding a hard time to strip of residual HSQ ( Fox 16) after using it as a mask in etching? We are coating 600 nm thick HSQ and writing with 3000 microC/cm^2 dose at 1 nA current. We are...
08 December 2020 5,452 2 View
I am working with oral cancer cell line SCC090 (ATCC). As per ATCC data sheet it is originated from metastatic tongue. It's primary site is not mentioned. Due to the origination from metastatic...
08 December 2020 5,674 3 View
My sample size is more than 750 but sk test is showing non-normal distribution. The variables have several outliers but I shouldn't remove those. In that case what should I do? t-test or other...
06 December 2020 1,285 19 View
I am working with oral cancer cell lines and trying to find the expressional changes of HIF1alpha under different experimental treatment. I am getting intense band of HIF1alpha in the western blot...
29 November 2020 5,707 3 View
I am working with h-BN and need to find out the strain due to in-plane lattice constant. The famous Williamson-Hall method may not be applicable here as it analyzes XRD for calculation of strain...
19 October 2020 7,386 4 View
Hi all, I am validating a polyclonal antibody raised against human ANT4, through WB and ICC. In most of my controls, the antibody shows very little off-target binding, but when I pre-incubate the...
03 March 2021 5,999 3 View
I am on the lookout for the Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence. Does anyone know where I can find it? Thank you in advance
03 March 2021 3,568 1 View
Is it possible to induce site-directed substitution mutation by quick-change method on linear dsDNA? or it has to be cloned in some vector? If yes, should it be treated with the Dpn1 enzyme...
03 March 2021 401 4 View
I need to prepare a solution of Napabucasin (inhibitor of cancer cell stemness) in dichloromethane. The drug is expensive, so maybe somebody already tried to do it. If it is soluble, what is the...
02 March 2021 9,945 3 View
im working now on TPV solar cells and metamaterials and i realy need our help in CST microwave i have a tpv cell simulation and i want to extract particullarly the absorbtion of only the active...
02 March 2021 2,246 2 View
Hello, Is it possible to use pUC19 as a transfer vector to be packed in using the second generation viral particles packaging system( pMD2.G; psPAX2 plasmids)? As far as I understand it there is...
28 February 2021 4,868 2 View
28 February 2021 2,534 2 View
I have two groups of brain samples, control and treated for example. It was total RNA nova seq sequencing. I tried all the available pipeline like: star+rsem+deseq2, Hista+stringtie+cuffdiff,...
27 February 2021 356 6 View
I diluted siRNA and RNAiMAX in opti-MEM and added to the cells which they were in the growth medium. Is it a right way? or should I culture cells in the opti-MEM medium for a while and not in...
26 February 2021 10,041 3 View
When using a lentiviral vector for inducible expression of genes using the Tet-On system. In the literature, I saw a widely used of pLVX-TetOne-Puro Plasmid, is there a reason why people prefer to...
25 February 2021 1,011 3 View