Why BJT has higher gain than the FET? Can some one give me the small signal model for Fin FET?
Dear All, The neutron cross section of element generally falls with the increase in neutron energy. But in U-238 the fission cross section at Neutron energy of 1MeV is 0.3 barns whereas it...
02 March 2017 1,600 4 View
Is there any mathematical formula there for the ideality factor of the diodes? I will be very much thankful for the above. Please send the mathematical expression for it.
08 September 2016 6,873 5 View
In the radiation detector the pulse shaping circuit consists of CR-RC circuit and amplifier.The function of pulse shaping amplifier is to improve Signal to Noise ratio.It also act as a filter to...
08 September 2016 8,346 4 View
Generally there are three types of noise is present in the semiconductor radiation detector.These are Thermal Noise,Shot noise and Flicker Noise.The thermal noise is removed by operating the...
08 September 2016 9,187 2 View
Dear All, Is there any technique other than the CVD to coat the Enriched Boron-10 on the Si surface? I will be very much thankful for the reply. Thanks & Regards Manoj
08 September 2016 8,542 0 View
08 September 2016 4,031 4 View
I have performed the neutron irradiation on the PIN Diode. I have found that the forward bias cut-in volatge has been shifted. Why these shift been observed in the neutron irradiated PIN...
06 July 2016 7,854 3 View
In the depletion region only uncovered ions are exiting then why we have the maximum electric field at the center of the junction?
06 July 2016 7,199 6 View
06 July 2016 6,512 2 View
Dear All, For the common mode signal the input voltage is calculated as (V1+V2)/2. Why we are calculating the common mode input signal as (V1+V2)/2 whereas in differential mode the input signal is...
04 May 2016 1,958 1 View
Hi, I am trying to construct a multi-layer fibril structure from a single layer in PyMol by translating the layer along the fibril axis. For now, I am able to use the Translate command in PyMol...
02 March 2021 4,569 4 View
Hello! I have a dataset of n=3000 nested within 8 countries with approximately 200 or 400 responses in each country. I originally planned to perform multilevel modelling with 4 dependent variables...
02 March 2021 6,865 1 View
In R-studio, there are many commands of Gumbel package. Arguments are also different. I`m asking about the alpha parameter of the Copula which must be greater than 1. If this is the one used to...
25 February 2021 5,229 3 View
I want to map these river geoforms with as little subjectivity as possible. I have a high resolution DEM generated by drone data.
22 February 2021 7,800 3 View
I am planning to work on T2 diabetic animals and check the efficacy of probiotics. My initial plan is to fed B6 animals with HFD for a while. But now, I have the chance to work on ob/ob mice. My...
18 February 2021 6,896 3 View
Hello, I am working on a global scale hydrology GIS project delineating global watersheds and doing some data analysis. I have in the past used hydro1K from the USGS that cover the entire world....
18 February 2021 5,109 5 View
Hello everyone, hope you are well. I am planning to use a Generalized Linear Model in SPSS. I would like to add gender to the model as a covariate, however from what I have read, only continuous...
14 February 2021 8,937 4 View
Hi everyone, I'm having some questions about choosing the right test for my experiment and I hope I can find help here! Here are the settings of the experiment: 1. participants are randomly...
14 February 2021 1,028 4 View
HI all, I have been working with daily diaries data ( 6 emotions of which 3 positive and 3 negative) were assessed for 30 days. These observations (1level data) are then nested within subjects...
13 February 2021 1,810 3 View
Hello, I have a question regarding non-parametric alternatives for a RM-ANOVA. In my study I had two groups that were measured on two timepoints (pre-post measurements only). I was planning to...
11 February 2021 8,599 7 View