Hey, I'm looking for a FEM analysis software to evaluate the displacements in a rock mass due to a presence of a specific gravity dam. I already have the strength and deformation properties of the rock mass and the dam.
The best software for analysing the stability of your problem is PLAXIS or FLAC..these two software is well established software for geotechnical engineering problem..among these two software PLAXIS is finite element based and FLAC is finite difference based software.. You will find lot of literature related to your topics ..the simulation of material properties in the analysis is very important..you will find rock joint rock model based Hoek and Brown method is available in PLAXIS..ABAQUS is basically developed for mechanical engineering and now civil engineers also using this software for various analysis..you choose the software as per your requirements and limitations of the software..ok all the best in your research..
I have performed almost the same analysis that you mentioned on a concrete-faced rockfill dam with RS2 (Phase2). It is relatively easy to use and developed by Rocscience Inc. You can also perform three-dimensional analyses with RS3.
The best software for analysing the stability of your problem is PLAXIS or FLAC..these two software is well established software for geotechnical engineering problem..among these two software PLAXIS is finite element based and FLAC is finite difference based software.. You will find lot of literature related to your topics ..the simulation of material properties in the analysis is very important..you will find rock joint rock model based Hoek and Brown method is available in PLAXIS..ABAQUS is basically developed for mechanical engineering and now civil engineers also using this software for various analysis..you choose the software as per your requirements and limitations of the software..ok all the best in your research..