Which is the best technique to extract coelomic fluid from Eisenia fetida?

Irina Patricia Tirado-Ballestas @Irina_Tirado-Ballestas

07 July 2018 0 9K Report

I am having trouble to extract the coelomic fluid from E. fetida. I am doing thermic shock with buffer solutions but I do not isolate enough.

Thank you.

Badges
Science topic

Similar topics
Phytochemistry
Extracts

More Irina Patricia Tirado-Ballestas's questions See All

What is the price (average) in USD of Microwave-assisted hydrodistillator with a 1000 mL flask?

I need to buy this equipment to obtain several essential oils.

18 February 2024 401 0 View

How is objectively measured the degree of criminality in patients (e.g. high burden of violence) in clinical studies?

In developing countries violence is one of the most important determinants of trauma. Some patients recurring this situation are usually implicated in delinquency (or poses history of...

22 April 2023 633 1 View

Do you have the LC50 of glyphosate for the biological model Eisenia fetida?

I need to know this information in order to develop an ecotoxicology bioassay, but I have not find the exact data.

03 August 2022 8,797 1 View

Measurement of an intracerebral collection (hematoma, abscess, cyst) depends on morphology? Sphere vs Ellipsoid formulas.

Current knowledge indicates the ABC/2 formula (simplified version of 4/3 π x (A/2) x (B/2) x (C/2)) to measure the volume of an intracerebral collection (either hemorrhage or abscess or cyst)....

01 January 1970 6,328 0 View

Strugglling with m6A dot blot any suugesstion ?

I have been doing the m6A dot blot for a while with no improvement, I am extracting the RNA, and I can see the dots although the three biological replicas give a different reading on the memberan...

10 August 2024 8,539 5 View

How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?

09 August 2024 7,718 0 View

AMAXA Lonza nucleofection lower volume of buffer?

Does anyone tried to do nucleofection with AMAXA by Lonza with lower than recommended amount of buffer in the cuvettes (100 ul)?

07 August 2024 4,616 0 View

Why I can't see any band in SDS-PAGE?

Currently, when I run SDS-PAGE, I don't see any bands at all, even though I used the same material just a day ago and it worked fine.... In our lab, we dilute the 10X running buffer to 1X and...

06 August 2024 5,373 2 View

The aqueous fraction of the hydroethanolic extract is showing the presence of palmitic acid. What is the mechanism responsible ?

Palmitic acid presence in aqueous fraction

05 August 2024 8,624 4 View

Why might the impedance values for DI water and 0.1X PBS buffer solution exhibit a decreasing and increasing trend, respectively over time (HP 4194A)?

Hello everyone, I'm encountering an issue with my electrochemical impedance spectroscopy (EIS) measurements and would appreciate some insights. Experimental Setup: Electrodes: Gold interdigitated...

05 August 2024 3,783 2 View

Which solvent is better to dissolve with secondary metabolites extracted from fungi?

I work on MCF7 cell cell for anticaner purpose and I wa to do drug preperation the drug ( secondary metabolites extracted from Aspergillus) My question which solvent is better with these secodary...

03 August 2024 4,725 2 View

Where can I find free research instruments for Nursing?

for eg. transition shock scale

01 August 2024 5,998 0 View

For systematic review data extraction, should I use ITT or PP analysis, and count all randomized participants or only those who completed the study?

I am conducting a systematic review and meta analysis; as I am extracting data I realized there is a consort diagram that shows the number of patients from randomization till end of the study. So...

01 August 2024 9,993 3 View

What is the best blank for nanodrop if I want to read a recombinant protein concentration?

Is it the "elution buffer" or the "dialysis buffer"? Note: I'll be using NanoDrop OneC

01 August 2024 967 3 View