Which are the new novel Solar cell materials?

More Shridhar Mathad's questions See All

Which softwares are useful in graph theory and in particular in spectral graph theory?

Path Eigenvalues and Path Energy of Graphs

19 September 2020 8,258 7 View

Is it possible that FWHM is same for all the XRD peaks of a particular material?

Hello, I am doing XRD data analysis of a certain material which may have more than one phases. While calculating crytallite size I noticed that almost all peaks have same FWHM except 3 peaks. Can...

03 February 2020 7,303 1 View

Where do we get characterization of nano materials like XRD,SEM,FTIR and dielectrical and magnetic studies as early as possible?

Where do we get characterization of nano materials like XRD,SEM,FTIR and dielectrical and magnetic studies as early as possible? Please help us.

20 December 2019 1,516 3 View

What is the minimum time required for a standard ligation reaction using T4 DNA ligase at 1U/ul concentration?

Hello everyone, I have a vector backbone of 5.5Kb in which I need to ligate an insert of ~600bp. The Roche T4 DNA ligase manual I'm using says ligation should be kept for 16h @ 16 deg. Celsius. My...

17 December 2019 4,523 8 View

Is it possible for an E. coli cell to have different morphology during growth?

I have been growing E. coli host in SM6 medium for fermentation. During the run, I did microscopy and found long filamentous rods, which are Gram negative. I have started searching literature for...

13 May 2019 879 8 View

How do you write a good review paper?

What is a scientific review article? How do you write a review article format? How do you write a scientific journal article? How do you write a good review paper? How do you write an introduction...

15 March 2019 424 5 View

How to write a better research projects? Kindly share some samples in material sciences?

Dear Sir/Madam How to write a better research projects? Kindly share some samples in material sciences? I am working in the field of ferrites and ferroelectrics. KIndly share some documents or...

17 October 2018 8,848 3 View

Need to know if higher IPTG concentrations make E. coli expression host undergo a metabolic stress?

Hi, I have been titrating best IPTG dose for highest expression of my GOI. However, I found that after a certain concentration (2.5mM), post-induction OD600 of culture shows lesser growth and as a...

28 January 2018 1,522 3 View

What is the best way to purify tagless and soluble TNFa?

I expressed TNFa in E. coli BL21 (DE3) host and got satisfactory expression. The protein is tagless. My question is how do I purify it? Which chromatography techniques can I use and what should be...

22 September 2014 918 17 View

Electrolytes in Supercapacitors

Hi, Can anyone help me, I want know, which materials can we use as electrolytes in Supercapacitors other than Potassium hydroxide and Sulfuric acid. For better power density or energy density.

05 October 2010 8,863 3 View

flexibility of polymers chain

effect of double bond on the flexibility of polymers

07 April 2021 0 0 View

Formulation of polymer color flakes

I am writing to request some information for making polymer color flakes. I would appreciate the help.

17 March 2021 0 0 View

Why does blocking with my immunogenic peptide cause nuclear fluorescence in ICC?

Hi all, I am validating a polyclonal antibody raised against human ANT4, through WB and ICC. In most of my controls, the antibody shows very little off-target binding, but when I pre-incubate the...

03 March 2021 5,999 3 View

Irradiation data for JAPAN?

Hi, Could you help me to get the latest (2019, 2020) solar resource data for a particular site in JAPAN? PV GIS and NSRDB data are not in reach to JAPAN, I'm looking for some other database for...

03 March 2021 961 3 View

Why are the velocities so high in my Boussinesq approximation Fluent simulation?

Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...

02 March 2021 4,910 3 View

Why Austenite grains in steel show much more twinning than ferrite grains?

It is oftentimes said to be a distinctive metallographic trait that differentiates a fully austenitic and a fully felly ferritic steel without etching that might distinguish between two. Why...

02 March 2021 728 2 View

Does Napabucasin soluble in dichloromethane and in ethanol?

I need to prepare a solution of Napabucasin (inhibitor of cancer cell stemness) in dichloromethane. The drug is expensive, so maybe somebody already tried to do it. If it is soluble, what is the...

02 March 2021 9,945 3 View

Help request in CST microwave?

im working now on TPV solar cells and metamaterials and i realy need our help in CST microwave i have a tpv cell simulation and i want to extract particullarly the absorbtion of only the active...

02 March 2021 2,246 2 View

Ester cleavage conditions?

Hi all, I need to cleave the ester in Ethyl 2-amino-1H-imidazole-5-carboxylate to make the carboxylic acid and retrieve the product from solution to use in downstream applications of linking to...

01 March 2021 8,766 3 View

Anyone found any research papers on solar furnace design calculations (for solar concentration)?

I am thinking about working on solar furnace with heliostats that concentrate sunlight and heat molten salt, but currently no luck with research. Not a lot of papers based on the subject. (check...

01 March 2021 5,023 5 View

Andrey Porokhnyuk

structurally, spherical silicone, while technically it is the same silicone, but in spherical micro-cells for superior robustness. the price is increased weight, and moderate efficiency of panels.

If you could implement some plasmonics on the surface of such spheres for effectively capturing light, that would be a breakthrough.