Where might one purchase regenerated cellulose dialysis membranes with a MWCO of greater than 50K Da?

30 May 2017 1 169 Report

I am in need of an autoclavable dialysis membrane with a MWCO around 100K Da, but I can only find vendors for RC membranes up to a MWCO of 50K Da. Any input on where to find a supplier would be helpful.

Adam B Shapiro

Here is a vendor for cellulose ester dialysis tubing with MWCO >50 kDa.

http://spectrumlabs.com/dialysis/dtList.html

Badges
Science topic

More Kyle Isaacson's questions See All

How to determine dilution factor of soil extracts?

Hello, I recently started working in a soil testing lab and am in charge of operating a new piece of equipment in the lab. We are using 4g soil to 40ml extraction reagent, shaking the mixture,...

26 June 2024 1,265 3 View

Why is Ethanol not precipitating our BSA?

We are trying to use 100% ethanol as a precipitant for Bovine Serum Albumin. The BSA is in a 0.5% concentration and we are using various ratios of ethanol to attempt to precipitate it, such as 1:2...

04 June 2024 8,024 1 View

RapidFire signal fluctuation?

Hello, Does anyone have recommendation on how to minimize signal fluctuation in RapidFire?

29 May 2024 5,094 0 View

How does the activity of lactate dehydrogenase in underfilled blood samples differ across various collection tubes?

This inquiry is related to a 2019 journal article authored by Nick Neuwinger et al., which explores the effect of underfilling vacuum blood collection tubes on the elevation of lactate...

05 February 2024 3,059 1 View

TiN etching through RIE?

Recently, I have been performing TiN etching using ICP RIE. However, I have encountered a problem in the process. Figure 1 depicts the maN-2403 PR after e-beam lithography, with a believed width...

27 December 2023 4,255 0 View

Has anyone experimented with APTES vs TMSPMA to bond COC to PDMS?

I was wondering if anyone has done a direct comparison for using (3-Aminopropyl)triethoxysilane "APTES" vs 3-(Trimethoxysilyl)propyl methacrylate "TMSPMA" as a surface coating/Functionalization...

30 November 2023 9,204 0 View

Is there a way to force NBO calculations in Gaussian to act as a single molecular unit?

I am trying to perform nbo calculations on an optimized structure using Gaussian software. I've included my input file as well as abbreviated NBO orbital interaction output. The separation of this...

26 November 2023 4,142 2 View

Protocol to establish a cell suspension Arabidopsis culture?

I am interested in starting a liquid suspension arabidopsis culture to provide a source of protoplasts. I have previously only used callus' for protoplast isolation. If anyone has a method of...

16 November 2023 295 1 View

In monogomous breeders with overlapping generations do you include the offspring in SPAGeDI analysis of Fst, Relatedness, and Sigma?

I'm assessing geneflow, relatedness and dispersal patterns in social mole-rats. They live in groups (4-15 animals) with high reproductive skew, 1 reproductive female and 1-2 reproductive males,...

08 October 2023 3,903 0 View

How does living in informal settlement affects psychological well being in manila slums?

This also includes eating recycled food and food insecurity

30 September 2023 4,649 0 View

Polymer wear calculation?

What is the method for analytically calculating the wear and service life of polymer-polymer sliding pairs?

04 August 2024 1,078 1 View

Simulation of metal drawing by Abaqus with UMAT?

Hello, colleagues. Recently, I have been working on a metal processing simulation with my UMAT in Abaqus. I have outlined the corresponding simulation, but I keep encountering issues that cause...

30 July 2024 7,062 1 View

How to explain the different interaction between soluble and insoluble polymer in water?

Hello everyone, I am try to understand the differences interaction between insoluble and soluble polymers in water with metal ions and how theit charge density (of metal ions) affect the interaction.

29 July 2024 6,350 3 View

Does post-translational protein modification cause devisions on observed pI verses calculated pI?

In running two-dimensional gel electrophoresis on bacterial protein, some spots that appear to match a protein sequence have a significantly more acidic isoelectric point than the calculated pI....

24 July 2024 8,076 3 View

Can a shoot-through event of a tri-state digital buffer cause momentary Hi-Z state?

// interested in the difference between floating events and short circuits.

22 July 2024 6,565 0 View

Is it possible to manufacture polypropylene sheets using a biaxial process?

I know that films and other low-thickness laminated products are produced using biaxial orientation, but is there something similar for sheets with a thickness of around 6 mm? Or are they...

21 July 2024 1,559 1 View

What is the difference between coordination polymer, MOFs, MCOFs?

Wherever I have referred, it puts me in a dilemma about the exact differences between these. It would be really helpful if someone can put me out of this trouble.

21 July 2024 3,045 3 View

Trial exclusion in eye-tracking data?

Is it reasonable to exclude all trials with a blink or saccade in the 150 ms before stimulus onset? As an alternative, would it be better to exclude blinks (after extending them by about 100 ms...

19 July 2024 3,838 0 View

Appearance of crystallization peak in heating cycle of DSC test?

For which types of polymers, the crystallization peak in heating cycle of DSC test can be observed and for which types cant? In another word, when this exothermic crystallization can be observed...

18 July 2024 348 3 View

Interpreting ATR-FTIR Spectra for Microplastics Research?

Hello everyone, I am currently pursuing a PhD in Environmental Engineering with a focus on microplastic studies. My background is in Civil Engineering, and I am relatively new to working with...

18 July 2024 7,258 3 View