Can accelerometer based wearable motion sensors be used to detect motion of fingers or a flex sensor is best suited for this?

I want to detect relative movement between fingers with wearable sensors. Which could be an appropriate technology for this?

31 December 2018 2,443 3 View

Can someone suggest me good book dealing with simulation of optoelectronic devices?

I am looking for a book to learn simulation of mostly semiconductor optoelectronic devices.

09 October 2018 351 0 View

What are practically achievable range and data rate for LoRa, SigFox and other IoT technologies?

If anyone has tested these IoT technologies in outdoor environment, could you please help me with max range and data rate that is actually achievable? I feel there is lot of difference between...

04 May 2018 1,299 0 View

What is the most suitable transceiver module for line of sight wireless transmission in 10 kms range?

I want a wireless transceiver module for remote sensing application with range about 10km. Xbee would not be sufficient. Can anyone suggest an alternative?

03 April 2018 5,651 10 View

Could anyone suggest some good journal to submit a purely theoretical work on semiconductor optics?

My work is related to theoretical modeling of a phenomenon in semiconductor lasers and I want to submit it in a reputed journal. Most journals in optics and photonics require experimental work....

02 March 2016 1,335 5 View

What is the physical significance of 'k' in a E-k diagram of a semiconductor?

What does 'k' refers to in a E-k diagram ? Is it a wavevector or something else?

01 February 2016 702 10 View

Is there any way other than "fft" to find the frequency content of a signal in Matlab?

I have complex values of a periodic signal which is clearly visible in time domain. But I want to find its frequency content ? FFT is not working with me and I am looking for alternate ways to...

11 December 2015 9,192 20 View

Can anyone suggest some good papers or books to study Optical Waveguide Analysis?

I want to learn optical waveguide analysis using methods such as FD, FDTD, BPM and EIM, but I am not sure how and where to start ? Any guidance will be helpful.

09 October 2015 285 11 View

How can the random noise sources like Angle Random Walk in a semiconductor gyroscope be theoretically calculated?

Is it possible to theoretically predict the magnitude of random errors in semiconductor ring laser gyros?

08 September 2015 6,951 0 View

Can someone suggest me a good tool for simulating Semiconductor Ring Lasers?

I want to simulate both integrated and bulk fiber-optic semiconductor ring laser. Which of the tools e.g. Lumerical, Comsol, OptiFDTD will be most useful to me?

08 September 2015 4,701 1 View

What is the most Operating System (OS) which can be INSTALL on Tiny hard devices like Raspberry Pi (RPi) hardware ?

I'm targeting to deploy a mesh network and manually configure MANET routing protocols. I'm preparing scenarios, architectures, and hard devices needed to do that. Are there some step-by-step...

03 March 2021 1,931 5 View

Waters 2707 HPLC autosampler problem?

I am using a 2707 waters HPLC device. When I try to inject a sample, it says missing plate or rack. I changed the needle and calibrated its position but I still get the same problem. I even get...

02 March 2021 1,408 1 View

What are anisotropic electrical and optical properties of a semiconductor due to?

In some materials, properties such as band gap, thermal conductivity differ along different crystallographic axes. What are the basics?

01 March 2021 1,923 3 View

How can I integrate a routing protocol in a tiny device (e.g. Raspberry Pi)?

Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...

01 March 2021 9,332 6 View

How to Eliminate cosine error and abbe error in LASER measurement system(for example Rhenishaw XL80)?

I like to do project in laser measurement system. My objective is to eliminate or reduce the cosine error, abbe error in Laser measurement system. I have Rhenishaw XL80 system. Please tell the...

28 February 2021 4,890 3 View

Gas sensor response and recovery time independant of flow rate and chamber volume?

I am trying to obtain the response and recovery times for my gas sensor device. It appears the the response/recovery times are primarily dependant on the flow rate of the gas I inject into the...

26 February 2021 1,511 3 View

How to measure angle between laser travel path and machine axis in Laser Measurement system?

25 February 2021 1,987 3 View

How to calculate battery consumption for IoT device?

Hi, everyone I'm working on a privacy-preserving algorithm that will apply to IoT devices. So, I need to measure the power consumption by implementing this algorithm. Any suggestion, advice,...

25 February 2021 8,749 6 View

How the Ground Plane implantation is performed without damaging (and w/o varying the undoped nature) the top Si (8-10 nm) in FDSOI technology ?

It is a general practice to introduce Ground Plane in FDSOI devices under the BoX. The Ground Planes are introduced by Ion Implantation through Top Si layer and Buried Oxide. I wanted to know that...

24 February 2021 5,974 4 View

How to troubleshoot Electrochromic Films and Electrochromic Devices?

I am trying to characterize an electrochromic system. The system uses ITO electrodes on glass, WO3 as the electrochromic film, and NiO as the ion storage layer. When I deposit NiO and WO3 and...

23 February 2021 9,592 2 View