How can the random noise sources like Angle Random Walk in a semiconductor gyroscope be theoretically calculated?

Arpit Arvind Khandelwal @Arpit_Khandelwal4

09 September 2015 0 7K Report

Is it possible to theoretically predict the magnitude of random errors in semiconductor ring laser gyros?

Badges
Science topic

More Arpit Arvind Khandelwal's questions See All

Can accelerometer based wearable motion sensors be used to detect motion of fingers or a flex sensor is best suited for this?

I want to detect relative movement between fingers with wearable sensors. Which could be an appropriate technology for this?

31 December 2018 2,619 3 View

Can someone suggest me good book dealing with simulation of optoelectronic devices?

I am looking for a book to learn simulation of mostly semiconductor optoelectronic devices.

09 October 2018 476 0 View

What are practically achievable range and data rate for LoRa, SigFox and other IoT technologies?

If anyone has tested these IoT technologies in outdoor environment, could you please help me with max range and data rate that is actually achievable? I feel there is lot of difference between...

04 May 2018 1,477 0 View

What is the most suitable transceiver module for line of sight wireless transmission in 10 kms range?

I want a wireless transceiver module for remote sensing application with range about 10km. Xbee would not be sufficient. Can anyone suggest an alternative?

03 April 2018 5,813 10 View

Could anyone suggest some good journal to submit a purely theoretical work on semiconductor optics?

My work is related to theoretical modeling of a phenomenon in semiconductor lasers and I want to submit it in a reputed journal. Most journals in optics and photonics require experimental work....

02 March 2016 1,472 5 View

What is the physical significance of 'k' in a E-k diagram of a semiconductor?

What does 'k' refers to in a E-k diagram ? Is it a wavevector or something else?

01 February 2016 1,042 10 View

Is there any way other than "fft" to find the frequency content of a signal in Matlab?

I have complex values of a periodic signal which is clearly visible in time domain. But I want to find its frequency content ? FFT is not working with me and I am looking for alternate ways to...

11 December 2015 9,340 20 View

Can anyone suggest some good papers or books to study Optical Waveguide Analysis?

I want to learn optical waveguide analysis using methods such as FD, FDTD, BPM and EIM, but I am not sure how and where to start ? Any guidance will be helpful.

09 October 2015 390 11 View

Can someone suggest me a good tool for simulating Semiconductor Ring Lasers?

I want to simulate both integrated and bulk fiber-optic semiconductor ring laser. Which of the tools e.g. Lumerical, Comsol, OptiFDTD will be most useful to me?

08 September 2015 4,819 1 View

What is the beam area of a laser wave and how to calculate it?

How do I find out the beam area of a light wave?

05 June 2015 2,891 0 View

Using OBD technique i am trying to measure laser induced shockwaves velocity i found that at start velocity increases and then decay?

i am unable to interpret why its increases in start as shown in figure

11 August 2024 2,179 1 View

Hello researchers Is this a random laser or just fluorescence?

I am using Rhodamine6G as gain medium and silver nanoparticles as scatterers on a microscope slide and laser input 532 nm comes from above.

09 August 2024 9,894 2 View

Could dyes amplify the spectrum of light to a specific wavelength?

I am interested to know the behavior of dyes toward light. Specifically, Blue dyes re-emit the spectrum, especially from the green zone (known as principal in LED lamps, and blue dyes are known...

05 August 2024 3,290 1 View

¿Are oxygen vacancies in semiconductors capable to change the band gap?

Dear all! Oxygen vacancies do raise negatively the Fermi level by increasing the negative charge in the semiconductor crystal structure. In the case of n-type semiconductors, I wonder if this...

30 July 2024 8,339 2 View

How to build my own lab made four point probe set up?

Hello, I'm trying to measure the conductivity of semiconductor films but since I don't have a commercial four point probe set up I would like to build one on my own in my lab. I have generators,...

30 July 2024 906 2 View

What is the relationship between the threshold voltage and the device's noise performance, particularly in terms of flicker noise and thermal noise?

The threshold voltage (Vth) of a MOS device plays a crucial role for its operation. At the same time, noise is an intrinsic factor. So how noise (flicker or thermal) change with the change in...

29 July 2024 3,246 0 View

How should operational parameters be selected when developing a pore-free laser welding technology?

There are three operating parameters - the laser power, the diameter of the focus spot and the scanning speed. It is necessary to obtain a seam of a given depth without pores. What parameter...

27 July 2024 7,168 2 View

Is it redundant to use both Random Forest and Decision Tree algorithms in the same regression project?

I am currently working on a regression model for a project and considering using both Random Forest and Decision Tree algorithms. Given that Random Forest is essentially an ensemble of Decision...

23 July 2024 4,306 3 View

Can we fit a gaussian Fit on a LIBS Peak ?

Though much literature suggests fitting a Voigt profile on a LIBS peak, is it also possible to fit a Gaussian profile on the LIBS peak? I have 204 spectra files, and I am building a pipeline for...

23 July 2024 6,127 1 View

How to download free version of BiofilmQ ?

I would like to use biofilmQ to analyse confocal laser image, how can do?

16 July 2024 7,628 2 View