How to etching sol-gel metal-oxide selectively?

04 May 2017 1,566 4 View

Can I use precipitated PZT suspension?

Like picture, PZT sol-gel solution became suspension by precipitationBut because this solution is not cheap commercial solution, I want use this solution continouslyDoes anyone have idea for...

31 December 2015 676 0 View

Isn't there any method that maintains constant temperature in metal alloy by joule(ohmic) heating?

When I induced current, temperature of alloy increase continuallyIsn't there any method that maintains constant temperature in metal alloy when joule(ohmic) heating?

06 July 2015 514 2 View

What are the new 2D nanomaterials were used for Silver nanoparticles stabilization?

In the stabilization of AgNPs are vital in current research interest. However, some of the 2D nano-materials like graphene oxide, MoS2, etc... previously used to stabilize it. But still they shown...

01 March 2021 2,207 3 View

How can we raise the figure when we writing a paper with Latex ?

Hi, everyone. I'm a starter to write a paper by Latex. But I have some difficulty using it. I'm writing the paper with 2 columns. And, there is one figure that occupies the 2 both-sides. I want to...

26 February 2021 3,738 3 View

Thermal reduction of graphene oxide.?

I am trying to reduce graphene oxide by thermally but I have no proper information regarding this. Can any one help me regarding the details about temperature and time for the reduction of...

23 February 2021 4,155 4 View

Is there an ideal incubation time of RGO-modified SPCE before subsequent use, i.e., electrochemical characterization or further modification?

I notice that upon washing and air-drying of my RGO/SPCE surface and characterizing again via DPV, the current response towards ferricyanide probe significantly decreases. My worry is that the...

22 February 2021 5,324 3 View

What is the best substrate for exfoliating few layers of hexagonal boron nitride (hBN) using traditional scotch tape method?

Unlike graphene, it is usually very difficult to exfoliate few layers (~10 nm thick) of hBN on SiO2 substrate due to lip-lip interaction at the edges. Au substrates have been proven very useful...

16 February 2021 2,635 2 View

How can I calculate teh crystallinity degree of graphene oxide?

I had treat my XRD diffraction pattern by Highscore to calculate the crystallinity degree Xc and I have the formula but I dont no the 2Theta of Ac and Aa to calculate Xc. Is it like polymers...

10 February 2021 6,305 5 View

About XRD details of pristine and doped RGO?

Hi Can anyone please help me know the XRD details of reduced graphene oxide, Nitrogen doped reduced graphene oxide, Sulphur doped reduced graphene oxide, Nitrogen and Sulphur co-doped reduced...

08 February 2021 3,033 3 View

What is the difference between Graphene Oxide and Expanded Graphite?

What are the main differences between Graphene Oxide and Expanded graphite, in terms of surface functionalities, conductivity, d-spacing and other features? Is the term expanded graphite...

06 February 2021 9,810 4 View

Why FTIR can not detect bases of nucleic acid in extracellular polymeric substances (EPS)?

I characterized functional groups of EPS using FTIR. Goups of sugars and proteins (e.g., -OH, amide, -COOH) as well as phosphate group of nucleic acid were readily detected. However, peaks of...

05 February 2021 4,405 1 View

Which solvent is suitable for product precipitation if reaction has been performed in toluene?

If condensation reaction happened between carboxylic acid and amine and amide is formed. The solvent for this reaction is toluene. After completion of reaction, how to collect product? It should...

03 February 2021 9,796 3 View