What statistical analysis should I run for eight groups with three factors?

More Md. Mustahsan Billah's questions See All

Does anyone have idea of dilution factor to measure SOD activity in SD rat testis by Cayman kit?

Hi all, I will be measuring SD rat testicular SOD activity using Cayman kit. This kit assay range is very limited (0.005 to 0.05 U/mL). Did anyone previously measure rat testicular SOD activity...

11 December 2019 1,230 2 View

Can I do Zinc assay in EDTA plasma?

Hi all, I have collected EDTA plasma. Now I need to do Zinc assay in that plasma. I found EDTA plasma is not recommended for Zinc assay. But still I saw many papers did this assay in EDTA plasma...

06 July 2019 9,236 1 View

Is changing the medium during the experiment overestimate the results?

I am experimenting with cancer and non-cancer cells in a 12-well plate for 4 days with a seeding density 1*10^4/well, however, I noticed that the control group growth rate slows down on D3. Should...

07 August 2024 2,283 2 View

Which solvent is better to dissolve with secondary metabolites extracted from fungi?

I work on MCF7 cell cell for anticaner purpose and I wa to do drug preperation the drug ( secondary metabolites extracted from Aspergillus) My question which solvent is better with these secodary...

03 August 2024 4,725 2 View

Can i quantify a nanoparticle encapsulated in cell culture medium by hplc?

Hello, if you made a transwell assay where you incubate the cells with a nanoparticle-encapsulated drug and considering that in the oposite compartment you'll have both the free and encapsulte...

03 August 2024 2,730 1 View

How to maintain the drug concentration in cell culture study for long term?

I am working in the filed of long acting drugs with Nano formulation. I want to study the efficacy of my formulation in 2D cell cultures while this required media change on every two days. In such...

24 July 2024 8,696 0 View

How can I determine if a drug binds to a ribosome using a Cryo-EM map?

Hello, I am searching for the binding position of a drug in a ribosome, based on previous work indicating it binds there. The resolution of the ribosome-drug Cryo-EM map is around 2.5 Å. I've been...

19 July 2024 2,155 0 View

How to calculate percentage cumulative drug release?

How to calculate percentage cumulative drug release when, Total volume of dissolution media = 250ml Added formulation was equivalent to 10mg of drug Sample withdrawn = 1ml each time Sink condition...

15 July 2024 4,192 1 View

MTT assay - 6 well plate?

Hi, In the 6 well plate, when I am seeding the cells. Do I add 1ml of complete media to one of the wells for the control at this stage or do I wait unit I am treating the plates to do that? Also...

13 July 2024 9,783 1 View

How to convince decision makers to adjust the legislation to allow opening of drug consumption rooms?

In my country, there is a lot of public outcry in relation to the presence of drug injection and related behaviors in public. Hence at least the bigger cities would probably benefit from the...

08 July 2024 8,903 1 View

Is the use of microcrystalline cellulose MCC 102 in direct compression technology justified, given the low flowability of this excipient?

Hello everyone reading this topic! It is well known that microcrystalline cellulose 102 is recommended for use in direct compression technology, however, like other grades, it has poor flowability...

08 July 2024 2,807 0 View

How am I supposed to find justifications for the unusual fatty acid profile in broiler diet?

I've obtained a fatty acid profile of broiler diet comprised of SFA 48 to 93%, MUFA (22 to 40%), PUFA (non determined to 10.4%. The PUFA composition is mainly n-6 and almost no value for n-3. The...

08 July 2024 9,165 4 View

Abhijit Das

Md. Mustahsan Billah the following link may be helpful for you.

https://www.researchgate.net/post/Which_statistical_test_will_be_appropriate_for_three_and_more_than_three_drug_treatments