How to culture mouse pheochromocytoma cells (MPC)?

Hi Everyone, Has anyone here worked with MPC cell line? Any tips or tricks? I am just venturing into cell biology and any advice on this topic would be highly appreciated. Thank you so much. Niusha

22 February 2021 3,891 2 View

No title

This phase is a ternary phase in Al-rich region of Al-Ni-Cr alloy system with a typical chemical composition of Al74Ni8Cr18.

06 September 2020 5,950 3 View

Is it possible to see the redox peak in CV while did not observe plateaus in the charge-discharge curves?

Dear researchers I see clear redox peaks in CV, but i did not plateau in the charge-discharge curves. Does anyone know the reason?

04 February 2020 707 9 View

Has anyone ever experience for Aflatoxin determination in meat by HPLC?

Has anyone ever experience for Aflatoxin determination in meat by HPLC?

29 December 2019 389 4 View

What are the antenna design challenges for 5G handset uses,these days?

any suggestion on recently designed antennas for 5G handset uses.

08 November 2019 5,509 4 View

Could phase segregation of soft and hard segments of a polymer (polyurethane in my case) create mico-cracks on the surface?

I see some micro-cracks on surface of PU. AFM phase images suggests that two phases; one rich in hard segment and one rich in soft segment exist on the surface as well as some micro-cracks on the...

13 March 2018 9,695 3 View

How can I measure CZTS charge diffusion length?

24 March 2015 6,554 2 View

How can I get a MATLAB function related to a multi class SVM classifier?

See above.

07 May 2014 3,895 1 View

Are there any studies about mental health before and after the Gulf War in Iraq and other countries?

We are designing a study about the effects of war on mental health of people of countries like Iraq, especially comparing the difference of political regimes before and after the war. Do effects...

19 January 2014 8,069 3 View

Hi, i dont know , which genes have a association between immunity and product traits in layer hens?

Can you write for me names of these genes?

10 September 2011 7,791 1 View

Can we recognize signs of the "volatility clustering" property of a time series in its time domain plot?

My purpose is to recognize the volatility clustering property without statistical tests such as The Lagrange Multiplier (LM) test.

24 February 2021 4,150 3 View

How to overcome convergence issues in concrete arch models?

Hi, I have modelled a three-span arch bridge with soil fill over along with pedestals. The FE modelling is done in LUSAS with HX8M solid elements (i.e. 3D solid modelling). The non-linearity is...

20 February 2021 1,346 2 View

What constraint can be used for rigid steel saddles and conrete beam under four point loading in ABAQUS?

Nodes are missing intersection with their respective master surface or outside the adjust zone, when using tie constraint.

01 February 2021 3,591 6 View

What stress-strain graphs do I put in a smeared concrete and steel reinforcement element in finite element analysis?

My SOLID65 element is reinforced concrete but what modulus of elasticity and material properties do I put? For nonlinear analysis

26 January 2021 1,704 3 View

Algebraic Loop Problem in PV array Solution?

I am doing a project with PV array in Simulink. When I run small section of the total system i do not get an error. But when i integrate full system(my system model`s are completely okay) I get an...

18 January 2021 685 10 View

Elastic constants -- transformation/basis change P21/a->P21/n?

Hi, I just calculated the stiffness tensor for a given material (a monoclinic molecular crystal) using molecular simulation. When trying to compare my results to published experimental results I...

05 January 2021 5,648 2 View

How to find the natural frequency of nonlinear model (hyperelastic materials) in ansys APDL?

I'm working on the FE analysis of nonlinear vibration of circular plate in ansys APDL. I considered the Mooney-Rivlin model of hyperelastic materials. So i want to know that how to find natural...

27 December 2020 8,696 2 View

How can estimate the Abaqus chaboche parameters from hysteresis curve?

Hello To validate the results of modeling by Abaqus software with experimental results, how can estimate the Chaboche hardening coefficients from the hysteresis curve? The material is steel.

21 December 2020 2,999 3 View

The loss of hyperbolicity in PDE?

Question about the loss of hyperbolicity in nonlinear PDE: when complex eigenvalues appear, what is the effect on flow? I understand that we do not have general results on existence in this case,...

16 December 2020 2,571 3 View

How to calculate tensile creep modulus of a liquid crystal polymer for a given load ?

Hi, I have the attached tensile creep modulus behavior for Vectra H140 (LCP material). The loads on the chart are 30 MPa, 40 MPa, whereas I am interested in the creep modulus for 15 MPa. Could...

15 December 2020 9,914 1 View