How does the grain size affect on density and heat convection coefficient?

How does increase of the grain size of steel influence the density and heat convection coefficient (Heat transfer coefficient) of the whole material?

22 November 2018 9,041 3 View

No title

I modeled a cylinder shell under the static compression load by Abaqus and could see the finite element results in Abaqus; however, when I want to optimize it via the optimization module in Abaqus...

31 December 2015 8,666 10 View

I'm doing a project to measure the factor to treat some of my aging problems. What methods can I use to measure the effect of that molecular factor?

My research budget is limited and I want to publish my article in the cheapest way possible. I wanted to find out between behavioral and pathological and other methods. What methods could I choose...

01 January 1970 6,062 3 View

Sample dilution for quantitative analysis using ELISA?

If the detection range is in ng/ml but the reference range is in ug/ml for a molecule or protein in serum or plasma .how to dilute and what is the initial volume to be taken for quantitative analysis

02 March 2021 7,670 3 View

Quantifying leaking DNA from bacteria - what's the secret?

Hi, all! I need to determine if my treatment causes membrane damage in bacteria (S. aureus and E. cloacae), but I cannot use a fluorescent probe such as PI and similar ones because my compound is...

24 February 2021 2,006 2 View

IF troubleshooting: looking at an intracellular protein that localizes to the cell's and how to reduce increase in signal due to cell ruffles?

I am currently trying to stain for PI3KBeta in MDA-MB-231 cells. My current issue is that 1) beta stains all over the cell and 2) there is an increase in signal at the edge of the cell and this...

24 February 2021 8,582 1 View

How can I verify my centrifugal fan design for electric motor cooling?

I have radial blade centrifugal fan design which will be mounted on exhaust side of electric traction motor. The fan will be mounted on same motor shaft inside the housing. How can I verify that...

23 February 2021 2,390 3 View

Is it efficient to do liquid biopsy to investigate the gene expressions of the tumor?

To do liquid biopsy and look for specific gene expressions there are so many published papers. Thera are different protocols and procedures used to isolate circulating cell free RNA or mRNA from...

23 February 2021 7,326 5 View

How to clean up TEM grid with plasma cleaner?

I need to clean the hydrocarbon contamination on the carbon substrate of TEM grid. However, I heard that substrate could be broken by the powerful plasma. My substrate is pure carbon, with ~3nm,...

23 February 2021 3,262 5 View

Are ZnS nanoparticles moisture sensitive?

Hello Everyone, I tried to form ZnS nanoparticles using the hot injection method and was able to form the same (confirmed by XRD). When I centrifuged, after the reaction I got a kind of white...

17 February 2021 1,709 3 View

No title

17 February 2021 4,217 3 View

What are the best cations for preparing competent cells, Ca2+ or Mg2+?

I have been reading various articles and most state that treatment with CaCl2 produces higher efficiency of transformation than MgCl2. Can anyone explain why Ca2+ is better than Mg2+ at...

16 February 2021 8,519 5 View

Peptide precipitation as pre-step for acid hydrolysis for amino acid analysis?

I'm currently experiencing problems during acid hydrolysis for total amino acid analysis as my first samples contain high amounts of sugar (I get too low results back). I therefore had the idea to...

14 February 2021 6,049 3 View