What is the use of potential energy distribution (PED) that can be got by the software CHARMM and how can it be exploited?

More Aravindan Arun Nadaradjane's questions See All

What may be the reasons for failures of Tube toi Tube Sheet Joints in Boiler Drum ?

We have observed that tube to tube sheet joint leaked in our boiler and needs to overcome same by knowing the root cause.

08 August 2024 3,161 0 View

Propose a comprehensive plan to design the new telecommunication system for the company, considering the following aspects:?

a) Design a scalable and robust network architecture that can handle the increasing data traffic and support various communication technologies. b) Recommend suitable transmission technologies,...

10 June 2024 2,187 1 View

How to plot axial ratio for a circular polarizer using hfss?

need details

20 April 2024 4,660 0 View

Need journals on kaolinite clay and biopolymers?

I need more articles on kaolinite clay and the same clay treated by number of geotechnical methods

14 February 2024 607 2 View

Hello all, How to calculate mean gas temperature inside the chamber at different crank angles using pressure data at that particular crank angle?

Pressure data has been recorded at each crank angle in a diesel engine, and I couldn't able to understand how to calculate the temperature from that data. is it possible or any other way to...

24 January 2024 2,926 3 View

The most welcome morning breakfast beverages are tea(black, green, oolong) and coffee(filtered, instant: both dehydrated and liquid). What do yo like?

Dear All, As I mentioned in the question itself these two beverages are saught after worldwide as a refreshing drink. Though, I like both tea and coffee the personal preference on day to day...

02 November 2023 2,011 8 View

On WIEN installation, problem with dstart?

I am new to WIEN and have been reading and looking at youtube installation instructions. However, I have not been able to make a clean installation. Errors start with SCF calculations where dstart...

02 September 2023 9,675 0 View

Purpose of reference electrode and counter electrode in supercapacitor?

22 August 2023 4,341 4 View

Purpose of reference electrode and counter electrode in supercapacitor?

purpose of reference electrode and counter electrode in supercapacitor?

22 August 2023 2,710 3 View

Anyone having issue with derivatization of amino acid using Fmoc?

I have to detect glutamine from a biological sample using HPLC/LC-MS. However, glutamine is very polar and doesn't bind to the column nicely. I used Fmoc to derivatize glutamine so that it can...

10 August 2023 5,839 3 View

How to learn more about SPSS and its Application?

I would like to learn more about SPSS and Its application especially in regards to data analysis. Please suggest me how I can learn more about it. Thank you so much.

11 August 2024 9,101 4 View

Can I base on reverse DNA sequences to perform alignment, convert to amino acids and GenBank submission?

I have reverse sequences (AB1 format), can I base on reverse DNA sequences to perform nucleotide alignment, convert nucleotides to amino acids and deposit the sequence in GenBank database?

11 August 2024 5,138 1 View

Baseline drift in HPLC? What causes this?

Hello, Why do i see this baseline drift when i compare my blank (black) to the sample (blue)? Any suggestions as to why this happened? Thank you!

11 August 2024 3,770 4 View

Text-Communication from the M1 Hand Area using BCI—and then there is Elon Musk?

Willett, Shenoy et al. (2021) have developed a brain computer interface (BCI) that used neural signal collected from the hand area of the motor cortex (area M1) of a paralyzed patient. The...

10 August 2024 7,180 0 View

Has anyone applied Python in the field of textile engineering for data analysis, automation, or smart textiles?

I'm currently exploring the application of Python in textile engineering, specifically in areas like data analysis, process automation, and the development of smart textiles. I'm interested in...

10 August 2024 7,429 2 View

How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?

09 August 2024 7,718 0 View

GC-MS retention index prediticon?

Hello experts, Does anyone know any free software about retention index prediction ?

08 August 2024 7,403 2 View

How are iso-frequency contours plotted?

Let's say we have a standard, regular hexagonal honeycomb with a 3-arm primitive unit cell (something like the figure attached; the figure is only representative and not drawn to scale). The...

07 August 2024 1,937 1 View

How to prepare the nanoparticle treated fungal sample for Environmental SEM analysis?

A fungal strain was treated with nanoparticles. We want to do an environmental SEM analysis. So could anyone share your views on preparing the sample? Thank you.

07 August 2024 5,307 1 View

How to normalize and take the significance of the MTT OD values with 3 replicates for the same cell-line?

Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...

07 August 2024 8,106 4 View

Justin Lemkul

http://www.charmm.org/documentation/c37b1/vibran.html# PED

http://www.charmm.org/ubbthreads/ubbthreads.php?ubb=showflat&Number=24876

You may want to post your questions to the CHARMM forum.

Aravindan Arun Nadaradjane

Thank you very much for your interest, Justin. I already tried that website. But I don't get the big picture of how can I use it.

@Justin: Yeah I try to post my question to the CHARMM forum as you said. Thank you.