12 December 2018 5 3K Report

To determine fracture behavior in multi phase steels

More Hassan Liaquat's questions See All
How to differentiate between different crystal lattice of the same grain. As they have same orientation and unit cell structure?

If i am wrong, please correct me

31 December 2017 1,023 0 View

How to analyze thermal stress due to Sliding friction in Ansys WB?

I want to analyze thermal stress due to sliding friction between two bodies in Ansys WB and also resulting change in temperature at the mating surfaces.

04 May 2016 1,430 5 View

Similar questions and discussions
How can I apply boundary conditions in an orthotropic steel deck numerical model using ABAQUS software?

I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...

08 August 2024 719 0 View

How to fix errors in my heat transfer steel structure with reinforced concrete slab model Abaqus?

I have modelled a steel structure using beam elements in Abaqus and attached to this structure reinforced concrete slab. The analysis that I am making is heat transfer of the structure. The...

07 August 2024 1,028 0 View

In the situation below, can I apply braun and Clark thematic analysis?

I have a theoretical framework for preparing a interview guide to assess the unmet care needs of a sub population of chronically ill patients and their caregivers(dyadic interviews).

04 August 2024 8,798 7 View

What should be the sample container for the hydrothermal reaction in a microwave reactor at 180 °C for 10 min at the heating rate of 5 °C per minute?

Suggest one of them 1. Teflon-lined stainless steel autoclave: 2. Alumina (Al2O3) ceramic container

30 July 2024 7,326 1 View

How are aPTT and PT values reduced after hemodialysis compared to before dialysis value in patients with chronic kidney disease?

I am conducting my research regarding blood coagulation in patients with CKD. I observed a reduction in post hemodialysis aPTT and PT values compared to pre hemodialysis values. But most of...

30 July 2024 3,467 0 View

Will the catalytic effect of retained austenite happens in steels including RA?

The catalytic effect of retained austenite refers to the phenomenon wherein quenching steels with a small amount of retained austenite, when subjected to tempering at a specific temperature...

27 July 2024 8,508 0 View

Please investigate the effect of temperature and strain rate of hot deformation and the formation of delta ferrite in martensitic stainless steel 410?

Please investigate the effect of temperature and strain rate of hot deformation and the formation of delta ferrite in martensitic stainless steel 410?

25 July 2024 9,408 0 View

Can we eliminate the stress singularity at the tip of the crack by manipulating the elastic constants?

The aim of the research here is to prevent the propagation of the crack in the fabricated elastic medium with useful applications.

25 July 2024 9,976 3 View

How to saturate steel samples with hydrogen?

I have tried to saturate ferritic steel with hydrogen using the electrolytic method and H2SO4. However, the effect was very poor even after 3 days of "saturation". Can anybody help in choosing a...

24 July 2024 4,393 2 View

How are clinical and environmental yeast/fungal strains stored usually in mycology laboratories?

I understand a glycerol stock for long-term preservation would be ideal, but how are working cultures generally stored? Mainly concerning Candida spp. isolates. A few references mention that they...

22 July 2024 6,592 3 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close