Dr.Tariq Mahmood
1 mM?
Hi Sajjad,
1 ml of aqueous nickel chloride is diluted in the 100 ml of Distilled water (blank solution) .
Generally these methods are used to find the weight Percentages of elemnts in metals or alloys.
No Its not mM It is 1mm.
thats the one thing which confusing me.
Please, provide reference
here i highlighted that one line which i am asking. thanks
Based on Figure 1 " Nickel chloride solution 0.1 M"
"100 ml of 1 mm aqueous nickel" might mean 100 ml of 1 M aqueous nickel
Contact directly the author
I got comment on my FTIR data figure from a reviewer. The reviewer said "FTIR data in Figure should be repeated. there is no bassline." I made Y off set comparison graph of FTIR on OriginLab. Can...
03 August 2024 6,070 3 View
The entropy measured of molecular graphs plays a crucial rule. The network structures in some cases are very lengthy calculations to handle. Some author avoid to construct table where as most...
30 July 2024 3,126 0 View
I am seeking a PhD position in the area of Deep Learning, specifically in generative AI. Cn anyone of you help me finding a suitable supervisor open for a PhD candidate.
28 July 2024 1,849 1 View
The first step is to analyze a 2D molecular graph and implement partitioning techniques to calculate the topological indices. Secondly impose statically tools to generate QSPR model, may or may...
24 July 2024 9,644 1 View
Most of the time it is observed that in many manuscripts there are several typo error of topological calculation errors of calculation and partition of edges what ever the type of partitioning it...
22 July 2024 811 0 View
Why methanol and sulphuric acid, used in the analysis of polyhydroxyalkanoates (PHA) methyl esters by GC-MS? Additionally, why do we typically use non-polar solvents in GC-MS?
22 July 2024 1,210 2 View
How can I define Planetary motion in ABAQUS CAE, how define motion of three rollers around a central axis and passive rotation about their own axis?
16 July 2024 4,145 1 View
Hello, I want to load Remedesivir (RNA polymerase inhibitor) into mesoporous nanoparticles (MSNs). The issue is drug is temperature and pH sensitive and it degrades quickly. I need advice on its...
01 July 2024 889 3 View
Hello I have prepared metal nanoparticles and did zeta potential. Normally there is a single peak in sample but now there are 3 peaks. I prepared sample for analysis first I prepared 10 mg/mL...
30 June 2024 1,063 4 View
Hi I am trying to revive Pseudomonas aeruginosa from frozen glycerol stock and also from cryobeads. But there was no bacterial growth. I used nutrient agar, tryptone soy agar to streak on. Also I...
09 June 2024 6,651 9 View
I synthesized some paramagnetic cobalt and nickel complexes (expected to be Co(II) and Ni(II)) using a bidentate ligand - N of pyridine ring (aromatic) and O of P=O (aliphatic), and I obtained...
03 July 2024 3,410 4 View
I'm interested in Raney Nickel and its composition. While it's usually a Nickel-Aluminum (Ni-Al) alloy, I recently saw an article mentioning Ni-Zn and Ni-Sn as Raney Nickel too. #RaneyNickel...
11 June 2024 355 2 View
The synthesis of nickel oxide by the sol-gel method involved the utilization of specific chemical reagents. To be precise, a combination of 100 ml of distilled water, 2.49 nickel acetate, and a...
05 June 2024 761 2 View
Hi, I am experiencing a nickel leakage from my Cytiva 5mL His Trap column. I think this happened because air went inside the column due to the blockage (or clogging) of the column bed on top....
04 June 2024 3,887 0 View
What are the historical prices of nickel metal hydride (NiMH) or nickel cadmium (NiCd) batteries in $ per kWh from 1975 to the present?
13 May 2024 2,284 1 View
Suppose austenite finish temperature of Niti alloy wire A is 25 deg Celsius and Niti wire B is 35 deg Celsius. Which one is best recommended for Biliary stent application and why?
29 April 2024 7,585 0 View
I want to design an ELF handheld antenna to respond to frequencies from 5 - 50Hz. What would be the best economical core material to use? Also would you suggest method of measuring the...
25 April 2024 4,633 4 View
I have seen type of MOF powder perfectly 7:3 Ni/Fe by solvothermal method how ever when I put Ni foam in the autoclave and the same I can not have the appropriate MOF coating on that foam. I...
16 April 2024 6,554 0 View
I have done a stress-strain test and it looks like the picture attached. However, in here, I only have upper and lower plateau stresses. In Auricchio's model for the superelastic behavior of...
03 April 2024 9,575 3 View
Hi, Research gate! I need HELP! I'm trying to prepare nickel nanoparticles for my devices. I use the commonly used method from the article (DOI: 10.1002/adma.201405391). Briefly, 20 mmol...
31 March 2024 7,168 1 View