what is the effect of annealing on the pore size
The behavior of decreasing refractive index n for wavelengths greater than 700nm is an important result, because it corresponds transmission increasing of ITO /glass at near-infrared wavelength
11 December 2019 3,335 3 View
I have doped NiO with different percentage of In i notice that the transmittace decrese with doping except 5% In. What is the reason
04 May 2018 2,077 0 View
if the matrix was metal oxide and use any dopant material to get new physical properties we observe that some peak in the XRD pattern will disappear.
04 May 2018 4,833 3 View
I notice for a metal oxide when we we need this metal oxide to be doped , we must use doping with at least 8% wt in order to see some peaks belong to the dopant material in XRD pattern, other wise...
04 May 2018 1,650 4 View
as illustrated in the attached figure
09 October 2017 7,543 5 View
10 November 2016 9,338 2 View
materials
09 October 2015 2,354 0 View
Thank you.
01 February 2015 1,380 23 View
Incompletely cross-linked pdms are difficult to remove.
01 March 2021 798 3 View
We have deposited silicon carbide on carbon substrate using one PVD technique. Due to amorphous behavior of SiC at low deposition temperature, we performed heat treatment of those films at...
22 February 2021 2,072 3 View
21 February 2021 3,417 5 View
Hi everybody, please, can someone tell us if the transition metals (W, Fe, Ni, etc ...) in silicon destined for solar cell manufacturing can be detected by ED-XRF technique. Note that the...
18 February 2021 6,231 4 View
Hello, I am observing a nearly periodic background spectrum for a wide variety of SERS substrates. I see this response (attached below) for bare Au films, Cu films, and Au nanoparticles on...
15 February 2021 9,922 5 View
In our lab, we are trying to do real time PCR for some genes. One of them has a size of 85 bp. Whatever we do, we had an amplification in negative control. When we run agarose gel, it always a...
14 February 2021 9,750 11 View
Hi everyone. We want to know how can I remove the non-specific band amplification on this variant. Although the amplification of non-specific band is not as intense as the band that we want, but...
09 February 2021 588 2 View
Till now i haven't got any PCR amplified vp2 gene bands on specific annealing temperature and in step up PCR.
08 February 2021 819 4 View
My design contains three parts. A silicon rubber membrane is placed between upper and lower part. I want to calculate sound transmission loss by using comsol Multiphysic. There are lots of...
05 February 2021 466 4 View
I have synthesized ZnO thin films at four different substrate temperature say, 300, 350, 400 and 450C. and the samples were annealed at 450C for half an hour. the xrd result shown better...
04 February 2021 7,641 4 View