The transmittance of NiO doped with In of different percentage suffer a flacuation on their sites ?

05 May 2018 0 2K Report

I have doped NiO with different percentage of In i notice that the transmittace decrese with doping except 5% In. What is the reason

Badges
Science topic

More Nadir Fadhil Habubi's questions See All

How we can explain the increase in transmittance with the decrease of refractive index for ITO thin film near IR?

The behavior of decreasing refractive index n for wavelengths greater than 700nm is an important result, because it corresponds transmission increasing of ITO /glass at near-infrared wavelength

11 December 2019 3,488 3 View

what is The maximum temperature can we use to anneal the porous silicon?

what is the effect of annealing on the pore size

09 October 2018 5,864 0 View

Why we use metal oxide and increase the doping agent .some of the peaks disappear?

if the matrix was metal oxide and use any dopant material to get new physical properties we observe that some peak in the XRD pattern will disappear.

04 May 2018 4,985 3 View

Why for metal oxide we need high dopant in order to appear in XRD?

I notice for a metal oxide when we we need this metal oxide to be doped , we must use doping with at least 8% wt in order to see some peaks belong to the dopant material in XRD pattern, other wise...

04 May 2018 1,800 4 View

What is the reason for the appear of unknown peak near 3keV in EDX for MWCNT/Porous silicon?

as illustrated in the attached figure

09 October 2017 7,713 5 View

Can we use Burstein–Moss effect in explain the behaviour of nanostructure instead of quantum size effect?

some papers use Burstein–Moss effect for explaining the increase of energy gap in nano crystalline structure ,others use the blue shift due to Quantum size effect

10 November 2016 9,535 2 View

What cause the appearence of snof2 plane in sno2 doped by 10% flourine by spraying sncl4 with NH4F?

materials

09 October 2015 2,517 0 View

In which case can the crystallite size be the same as grain size?

Thank you.

01 February 2015 1,527 23 View

What is the reason for current dropping in OER , LSV curve?

I tried four trials of the same Copper Phosphides sample in Alkaline medium ( 0.5M KOH) with Hg/HgO reference electrode and Pt as counter electrode. I used 0.001 V/s scan rate for first three...

10 August 2024 3,629 1 View

What may be the reasons for failures of Tube toi Tube Sheet Joints in Boiler Drum ?

We have observed that tube to tube sheet joint leaked in our boiler and needs to overcome same by knowing the root cause.

08 August 2024 3,161 0 View

What is the problem with these tissue culture plants?

All plants are green but some of these plants becomes yellow. I did not found any reason. Please help me to find out the real problem.

01 August 2024 589 4 View

Reason for discontinuities in my Band structure?

Hey All! I am wondering what might be wrong with my band structure. I did the calculations using VASP and plotted the results using Origin. Although I have tried changing various input...

25 July 2024 2,920 11 View

Is it fare for editors of reputed Journals to put on hold manuscripts more than six months without review updates, Are they harassing researchers?

It is being seen that Editors of some reputed Journals are putting on hold the manuscripts and not updating review states even passing more than six months from submission. Researchers are...

24 July 2024 8,596 2 View

Has anyone tried freeze flow samples in -80C freezer or liquid nitrogen before processing?

Our lab has some radioactive cell samples that need to be kept frozen for at least 30 days before flow analysis. For some reason, the samples stored in liquid nitrogen did not perform as well as...

15 July 2024 9,975 1 View

My Cyclic voltammetry curve doesn't show cathodic peak of Cu2+ to Cu+. how to solve this problem?

I performed CV of Cu-MOF in a buffer solution of pH 8, and we did not find any peak corresponding to Cu2+ to Cu+. What is the reason behind this? Please give your valuable suggestions.

08 July 2024 2,388 4 View

Hello, I’m growing three species of microalgae under heterotrophic and mixotrophic conditions. Both the two turned yellow?

What could be the reason for mixotrophs to be yellow too instead of green? Thank you

08 July 2024 594 2 View

What are possible reasons for having the repeated wavy patter in Raman spectrum?

I'm currently analyzing the Raman spectra of coloured plastic samples and have encountered a wavy, oscillating pattern in the spectra of some coloured samples. I was wondering what the possible...

04 July 2024 1,949 4 View

Which river basin has lowest total replenishable groundwater resources &utilization of irrigation potential created lags behind potential created why?

Which river basin has the lowest total replenishable groundwater resources and utilization of irrigation potential created lags behind the potential created what are the reasons?

03 July 2024 9,638 0 View