What is the difference b/w a sputter target directly purchased from Alfa, etc., and a circular plate wire-cut from the thick plate of same purity?

Previously, we used to get a thick metal plate (similar purity as the sputter target) and wire cut it make as circular target of 50 mm dia. In this way, one gets 4 sputter targets with the same...

17 August 2020 8,811 3 View

Can any one help me in getting the list of scopus journals for MRI image processing using Deep Learning?

Can anyone help me in getting the list of Scopus journals for publishing MRI image processing using Deep Learning? and also let me know how can I get an authorized Scopus list where i can publish...

29 May 2020 340 2 View

How many number of primers of a gene to be used for its expression analysis using RT-qPCR?

Do we get any differences in assessment of gene expression using primers from many exons of a genes? In general, it is done using single optimised primer in Realtime PCR. What happens if two...

22 March 2019 7,385 3 View

Does solvent plays an important role in free radical polymerization? If yes how and if no Y?

what are the factors which will be effected by different solvents in free radical polymerization?

19 September 2016 2,576 4 View

How do I estimate hertability for the traits from the lines evaluvated in Augmented Block Design?

18 January 2016 410 2 View

How does one calculate the binding energy of a ligand to a particular protein?

How can I calculate the binding energy of a ligand to a protein? How is it different from the free energy of the ligand.

22 October 2013 555 3 View

Do the RAMAN and XRD give same information about the stress in thin films?

There is a large discrepancy in the stress values calculated by RAMAN and XRD. Which technique among these gives the right information?

10 June 2013 727 5 View

Antimicrobial activity of DMSO

Do DMSO effect the microoragnisms, if so what would be the minimum concentration to exhibit activity?

01 January 1970 3,576 16 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence?

I am on the lookout for the Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence. Does anyone know where I can find it? Thank you in advance

03 March 2021 3,568 1 View

What kind of fluid could I use for a pitfall trap that also does not invalidate molecular testing?

Hi, I want to start testing pitfall trap to obtain ants samples, but I need to conduct molecular analysis on those insects. So, what kind of fluid can I use? Ethanol expires too early and I need...

03 March 2021 5,978 5 View

Gel electrophoresis result for total RNA samples, 1.5 Agarose gel was used, How to improve the integrity of RNA?

Gel electrophoresis, RNA degradation, RNA extraction from fresh tissue

02 March 2021 5,433 5 View

How to repeat an operation on an atom selection for multiple times in PyMol?

Hi, I am trying to construct a multi-layer fibril structure from a single layer in PyMol by translating the layer along the fibril axis. For now, I am able to use the Translate command in PyMol...

02 March 2021 4,569 4 View