The message from the software is : THE INDEPENDENT VARIABLES MUST BE ARRANGED IN ASCENDING ORDER. THIS ERROR MAY HAVE BEEN CAUSED BY A POSSIBLE EMPTY LINE ON THE DATACARDS IN THE PROPERTY DEFINITION. and there`s no empty lines in the material data. I don`t know where`s the problem
Does your defined property has dependence on something like temperature? Make sure the reference data points are in ascending order, for example,
***[g/mm3]***
*DENSITY
7800e-6, 0
7760e-6, 200
Above format is OK.
But the fomat below will cause the error as you post.
*DENSITY
7800e-6, 200
7760e-6, 0
Does your defined property has dependence on something like temperature? Make sure the reference data points are in ascending order, for example,
***[g/mm3]***
*DENSITY
7800e-6, 0
7760e-6, 200
Above format is OK.
But the fomat below will cause the error as you post.
*DENSITY
7800e-6, 200
7760e-6, 0
respected sir,
chances of your material data sequences changes or column of material properties and fields variable data altered ..that's why this error get executed..please check it material properties data...
you should checK the property module or anywhere that you enter the temperature dependent properties. sometimes maybe a row is repeated or the data maybe entered in descending order
Please check the values of true plastic strain, these should be in ascending order. you have got this error because the values you entered for true plastic strain are not in the ascending order. Convert engineering stress strain curve into true stress and plastic strain and put this values in material property also make sure that these true plastic strain values should be in ascending order.
- Badges
- Science topic