In device catalogue both parameters have same dimensions (Bq/cm3).
I am working in a laboratory with Cov19. Extraction is doing kit but it isn't good and the amount RNA, 260/280 is higher than 3. Can someone help us in this regard?
12 September 2020 2,827 7 View
I'm going to produce depth video using a video with the right camera and a video with the left camera,(I mean two videos taken with the stereo camera).
16 October 2019 5,014 3 View
Hi I synthesized NiCoFe2O4 nanoferrite. I used XRD to prove the formation of NiCoFe2O4 nanoparticles. I understood that the position of the peaks is correct. I mean that the nanoferrite powder...
07 December 2016 7,735 16 View
does vitamin C and H2O2 have any chemical reactions which will prevent us from detecting Vitamin C?
15 August 2016 1,715 3 View
I'm working on uniaxial tensile test for an epoxy and crack propagation in it. I have data from my lab work and now I would like to model it in Abaqus. I made the bone shape sample and everything...
03 February 2015 8,650 1 View
NAFLD shares many overlapping features with the insulin resistance syndrome, also known as "Syndrome X" including central or visceral obesity, type II diabetes, and dyslipidemia. Of course, NAFLD...
14 September 2014 882 5 View
I'm targeting to deploy a mesh network and manually configure MANET routing protocols. I'm preparing scenarios, architectures, and hard devices needed to do that. Are there some step-by-step...
03 March 2021 1,931 5 View
I am using a 2707 waters HPLC device. When I try to inject a sample, it says missing plate or rack. I changed the needle and calibrated its position but I still get the same problem. I even get...
02 March 2021 1,408 1 View
Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...
01 March 2021 9,332 6 View
I am trying to obtain the response and recovery times for my gas sensor device. It appears the the response/recovery times are primarily dependant on the flow rate of the gas I inject into the...
26 February 2021 1,511 3 View
Hi, everyone I'm working on a privacy-preserving algorithm that will apply to IoT devices. So, I need to measure the power consumption by implementing this algorithm. Any suggestion, advice,...
25 February 2021 8,749 6 View
I am trying to characterize an electrochromic system. The system uses ITO electrodes on glass, WO3 as the electrochromic film, and NiO as the ion storage layer. When I deposit NiO and WO3 and...
23 February 2021 9,592 2 View
Hello Everyone, I tried to form ZnS nanoparticles using the hot injection method and was able to form the same (confirmed by XRD). When I centrifuged, after the reaction I got a kind of white...
17 February 2021 1,709 3 View
Hello researchers! While studying the literature on refractive index sensors, most of the articles simulate their devices with a refractive index ranging from 1 to 1.1, with small steps in...
17 February 2021 1,578 4 View
I tried to sweep my ferroelectric devices from -2V to 2V and then from 2V to -2V and The two hysteresis peaks are off by several microFarads. Should i increase bias voltage? I am doing these...
16 February 2021 8,514 2 View
The data collected from various measurement devices often contains erroneous values - such as noise, missing values, etc. What are the popular techniques for pre-processing measurement data in...
14 February 2021 4,642 2 View