Why there are two peaks while using the mie plot of Silver nanoparticle?

Hi, I am trying to learn the theoretical modelling of silver nanoparticle using the Mie scattering theory. After that, I discovered a software named Mieplot developed by Philip Laven, where it...

25 February 2021 7,493 6 View

Lift off problem with Indium/Gold deposition?

Hi, I'm doing 5/40nm In/Au e-beam evaporation at rates 0.2A/s(for In),1A/s(Au) on lithographically(doubly coated 495k,950k PMMA e-beam resist) done Si substrate at base pressure 2e-6torr. I'm...

18 January 2021 7,550 4 View

How much would be the particle size difference between Malvern Zetasizer Ultra Particle Analyzer and TEM for the same Nanoparticles?

I am measuring the particle size of nanoparticles by Malvern Zetasizer Ultra Particle Analyzer but I am not sure I would get a better size with TEM or not. Because I read in a paper that there is...

05 January 2021 1,612 8 View

What is the best way to conduct meta analysis ?

24 November 2020 1,318 8 View

Previously some data I have uploaded in mendeley data base and it provide DOI number. Can I published same data with another journal.Please suggest?

Previously some data I have uploaded in Mendeley database and it provides DOI number. Can I publish the same data with another journal ? Please suggest. Is there any problem of plagiarism with...

27 October 2020 2,801 6 View

Why a distorted admitance value is obtained while doing mixed mode simulation of TFET with dyanamic non local BTBT model in Santaurus TCAD ?

AC analysis of TFET device along with dynamic non local BTBT model shows a distorted admitance. But while using Local BTBT model a good values for the admitance is observed.

20 July 2020 2,465 1 View

If a system is stable in each of the operating regions, can it be said that the system is stable for the entire operating region?

If an operating region is divided into a number of sectors and if it is shown that the system is stable in equilibrium point corresponding to each of the sectors, can it be said that the system is...

21 March 2020 8,816 6 View

Which is the best instrument for the Soil Erosion Measurement?

I want to measure the soil erosion of a watershed. Is there any instrument which will help me to measure the soil erosion?

24 February 2020 8,934 22 View

How to do optimization by neural network in matlab?

I have used 30 experimental data set for ANN modelling (Matlab) and RSM based optimization (Design Expert). The RSM and ANN predicted data was compared and it was observed that the ANN model has...

30 January 2020 7,760 3 View

Where we can find the World geochemical background values of these heavy metals Fe, Zn, Pb, Cr, Cu, Ni, Cd for calc of sediment indexes?

These background values/reference values can be used for calculation of different indexes, viz. enrichment factor, geo-accumulation index, contamination factor, pollution load index and many more.

22 January 2020 8,948 3 View

New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before?

Question to you and THEM, the New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before? There appears to be a core problem for...

02 March 2021 3,024 2 View

Which is a lucid standard comprehensive book to guide on psychological scale construction and its standardization?

02 March 2021 7,082 3 View

LOAD DISPLACEMENT CURVES Stiffness increasing in ANSYS non linear analysis. HOW CAN I CORRECT IT?

Hi. I am doing non linear FE analysis using a new material beam under flexural 2 point loading using ANSYS. I have defined a bilinear material model. The solution has converged. In results I am...

01 March 2021 9,911 3 View

How to choose ANN number of hidden layers and nodes?

Hello, Could you please share any interesting research explaining how to choose the number of hidden layers and nodes per layer in case of regression problems using ANN? Thank you, any help would...

01 March 2021 6,200 3 View

PUC19 as a transfer plasmid for lentiviral delivery?

Hello, Is it possible to use pUC19 as a transfer vector to be packed in using the second generation viral particles packaging system( pMD2.G; psPAX2 plasmids)? As far as I understand it there is...

28 February 2021 4,868 2 View

How to eliminate Steady state error from Reinforcement learning genetic algorithm code?

The following code (see 1st 2 images attached) is used to produce PID controller values that are designed to control the system (G). The code finds the PID controller values (noted as k) by using...

28 February 2021 6,560 14 View

How could I take into consideration the weights of observation in a system of seemingly unrelated regressions (SUR) in rstudio?

I build a model of 4 regression equations (probit and OLS) in R studio. I need to take the weights of observations into consideration. While it is simple to do so for every regression equation,...

27 February 2021 1,233 1 View

Can random sampling have inclusion criteria?

As random sampling means that everyone in the population have an equal chance to be chosen, can it have inclusion criteria? My research participants have been chosen based on the inclusion...

26 February 2021 6,905 10 View

Do you kow of any database containing data on retention time, log P and polarizability for a large number of molecules?

Hi, I am a chemistry undergraduate doing my dissertation project on HPLC. In my project, I need to predict the HPLC retention time of 20 aromatic molecules, the calibration set. To do this I will...

24 February 2021 2,602 1 View

How to run raise regression in R?

if anybody know how to run raise regression in r, and raise parameter selection, please help me

24 February 2021 8,199 1 View