What data source of Albedo it's possible to use for hydrological modeling in SWAT?

More Alexandro Gularte Schafer's questions See All

How can i temporarily give my self schizophrenia?

i need to know how to give my self schizophrenia TEMPORARILY!!!

15 November 2023 7,226 3 View

What is the maximum concentration of Fe that can occur in groundwater?

Is an analysis of 61mg/L Fe (total) plausible from a deep confined siliciclastic aquifer ~420 m below ground level? Normally precipitation of FeS and FeS2 under redusing conditions will limit...

01 August 2022 1,872 4 View

Issues with PVA dissolution?

Hi - I am trying to make a 5wt% PVA (MW=130000) in water solution. I heated it for several hours at 90 degC while stirring, and left the solution to continue to stir overnight. I was able to watch...

18 April 2021 603 2 View

Could letters to the editor, such as publication in an indexed journal with an impact factor, be valid as a formal published article?

Dear researchers, I would like to know the opinion and analysis of researchers experienced in this matter regarding the value of the publication "Letter to the editor" in relation to the formal...

25 October 2020 6,153 14 View

Solubility of calcium ionophore II (ETH-129)?

Hello all - I am trying to add the calcium ionophore ETH-129 from Sigma ( https://www.sigmaaldrich.com/catalog/product/sial/21193?lang=en®ion=US ) to phospholipid bilayer/vesicles. The only...

03 September 2019 5,720 1 View

What are the main machine learning techniques for land use and cover classification using remote sensing images from Sentinel and Landsat sattelites?

I am start to study machine learning applicated to remote sensing (more specifically Landsat and Sentinel 2A and 1C images) and I would like to know the main techniques used for this.

05 August 2019 7,871 2 View

Adhering in vivo collagen samples to gold surface (QCM or SPR)?

Hello - I am trying to attach collagen fibrils (collected tendons in vivo from rats/mice, performed a trypsin-based or mechanical extraction to get only free fibrils) to a gold surface of a QCM...

13 March 2019 4,923 1 View

Which Sodium Citrate salt should I use for Trizol DNA isolation after RNA extraction ?

Hello everyone, I am trying to isolate DNA from the same sample from a previous Trizol RNA extraction (because our sample is very scarce). I followed the standard Trizol protocol (life...

24 May 2015 6,727 10 View

Ethics in counseling.

I've been looking for research regarding rights of the counselor. When the client is verbally abusive, slanders,or yells at the counselor over phone - how should the counselor ethically protect...

20 July 2013 5,570 1 View

Dr. Langford: Do you see any psychological correlations between climate change and the energy of human thought and feeling?

In quantum-mathematical fields of energy and information technology (ICTs) that are generated from a Monadic field as defined by Liebnitz, there must be correlations to archetypal and archetypal...

01 January 1970 8,432 10 View

How can I prepare virus for a TEM or SEM imaging?

I have virus (viral hemorrhagic septicemia virus) in suspension and the experiment will not involve cells. What level of TCID50 is preferred?

11 August 2024 3,115 1 View

Handling Missing Data and Building a Predictive Model with Incomplete Information ?

I am developing a predictive model for a water supply network that involves 20 influencing points. However, I only have historical data for 10 out of these 20 points. I would like to know how to...

10 August 2024 4,005 2 View

Is it possible to use the Fused Deposition Modeling (FDM) to additively manufacture interconnected porous structure generation of >100-200 micrometer?

Usually, additive manufacturing techniques like SEBM, SLS, and SLM are used for interconnected porous lattice structure generation with sizes of >100–200 micrometers. Can the Fused Deposition...

09 August 2024 7,892 0 View

How to define an anisotropic material with asymmetric elastic compliance/stiffness matrix in ANSYS APDL?

I need to model an anisotropic material in which the Poisson's ratio ν_12 ≠ ν_21 and so on. Therefore, the elastic compliance matrix wouldn't be a symmetric one. In ANSYS APDL, for TB,ANEL...

09 August 2024 5,048 2 View

How can I apply boundary conditions in an orthotropic steel deck numerical model using ABAQUS software?

I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...

08 August 2024 719 0 View

Can you suggest reliable sources defining "3D mesh" and "3D city models"?

Dear fellow researchers, I am currently working on a paper where I need to provide a reliable reference that defines and distinguishes between 3D mesh models and 3D city models. Although I am...

06 August 2024 9,986 2 View

Please explain how the plastic input value should be considered from the true stress-strain curve for the bilinear elastoplastic material model ?

I am working on Abaqus/Explicit(Quasistatic ) for the deformation of the auxetic structure model. Please explain how the plastic input value should be considered from the true stress-strain curve...

05 August 2024 454 3 View

What are the shear and normal stiffness values of an LLDPE liner in 3D numerical modeling of a stockpile?

I am seeking experimental or applicable data for the liner (LLDPE) interface in FLAC3D numerical modeling of a large stockpile. Could you please recommend suitable references? The preferred data...

05 August 2024 3,665 0 View

Is it necessary to covary exogenous constructs in a structural model?

I am working on a SEM model where i have 7 latent variables (6 exogenous and 1 endogenous). In AMOS when I co-vary the exogenous constructs, only 2 paths are coming significant out of 6. But when...

03 August 2024 6,028 4 View

Given the current level of natural phenomena cause by the climate change and environmental pollution, will the AI find the technological solutions?

AI-driven technologies offer previously unheard-of capabilities to process enormous volumes of data, extract insightful knowledge and improve predictive models, according to the UN’s World...

31 July 2024 9,733 3 View