Depending on the heat tolerance ability, types of used solvents and their interactions with composite material, you may choose simple drying, low pressure vacuum drying, freeze-drying, super critical drying or high temperature drying for the removal of the solvent molecules. You may see the following link'
Article A facile way to produce epoxy nanocomposites having excellen...
http://composite.kaist.ac.kr/public/NPE163.pdf
Article Sustainable nanocomposites of epoxy and silica xerogel synth...
Mr. Abdur Thanks for the answer and the share; I will go through the article. I am actually using acetone as the only solvent. I am going to coat epoxy over a steel substrate. Will curing epoxy according to recommended conditions after coating remove the solvents ?
If the solvent is water it is easy to remove from the polymer via freeze-drying under vacuum, if not then only slow drying in vacuum.Or rinse in a boiling solvent.
I do not know the type of epoxy resin you use. If it is an aromatic epoxy like DGEBA - you should keep in mind that the destruction of composites based on DGEBA starts around 160C. About 30 years ago the scientists tried to measure the free volume enclosed in cured DGEBA. For that purpose they used a long-term (say, 5-7 days) vacuum treatment at very high vacuum appr. 10-5 - 10-6 mmHg.
Rotary evaporation could be used to remove the solvent. You can refer the manuscript Polymers 2017, 9, 106; doi:10.3390/polym9030106, for further details.