10 May 2021 1 3K Report

I am looking for effective articles on the mass spectrometry elucidation signalling hubs in cellular stress pathways to investigate cellular plasticity and adaptation?

More Amit Kumar Acharzo's questions See All
Please explain how the plastic input value should be considered from the true stress-strain curve for the bilinear elastoplastic material model ?

I am working on Abaqus/Explicit(Quasistatic ) for the deformation of the auxetic structure model. Please explain how the plastic input value should be considered from the true stress-strain curve...

05 August 2024 454 3 View

Potential Vs current density(mA/cm-2) in EC-Lab?

In Zn-Air Battery, how to plot Potential vs current density(mA/cm-2) in EC-Lab softare/BioLogic instrument. Please suggest. plot of the ref....

04 July 2024 3,807 2 View

I am conducting an experiment for oxidative stress assay for C.elegans for a phytochemical and for FUDR needed to added at L1 or L4 stage?

and will i add phytochemical along with FUDR?

28 June 2024 6,254 0 View

Are These Dates, Months, and Seasons Accurate for Agricultural Planning in Bangladesh?

As many of us know, there is often confusion regarding the alignment of dates, months, and seasons in our agricultural practices. To address this, I have prepared a table that aims to provide a...

27 June 2024 7,749 1 View

How to plot Potential vs current density(mA/cm-2) ?

In Zn-Air Battery experiment, how to plot Potential vs current density(mA/cm-2) from discharge voltage curves. Please suggest.

23 June 2024 860 2 View

In Abaqus, How to determine cracks in the macro model 3D structure having element type C3D8 as wall brick mud masonry element?

A masonry structure modelled all the wall using macro element and performing non linear time history analysis in dynamic explicit . I need to determine the random cracks where a give stress...

01 June 2024 1,349 1 View

How to Calculate the PEEQ for Mohr Coulomb?

Hi, I want to calculate the plastic equivalent strain for Mohr-Coulomb. I found a formula from Abaqus documentation. I have attached the photo of PEEQ calculation. But I want to figure out the...

28 May 2024 9,081 1 View

Is there any set method or Theory Available to improve the performance of Fuzzy logic controller?

If the Fuzzy logic controller is not giving the desired results than what to do ? Further more...How to know how many membership functions and which type should be chosen?

20 May 2024 628 0 View

How to isolated bacteriophage with lytic activity from water and other samples?

My student is isolating phages against ESKAPE pathogens, but she is getting a minute plaque. Can you please suggest how to get better results?

07 May 2024 9,554 2 View

I already added references using Mendeley reference manager, is their anyway i can change it to zotero or any other reference manager?

I have added references using Mendeley reference manager, but it ruined the manuscript; it doesn't take ACS or other journals references properly except elsevier, and multiple duplicates are...

22 April 2024 6,560 1 View

Similar questions and discussions
Can you connect an HPLC to a Mass Spec only at a certain time point?

Can anyone explain this method? Especially the last statement where it says only at 1.5 to 2.5mins was the MS/MS connected to the UPLC. How is that possible, is it a feature in this specific...

11 August 2024 8,141 3 View

GC-MS retention index prediticon?

Hello experts, Does anyone know any free software about retention index prediction ?

08 August 2024 7,403 2 View

How to calculate CCS for Sodiated adduct ions and Multiply Charged Ions?

I'm currently working on calculating the collision cross section (CCS) for various ions, and I'm facing challenges when dealing with sodiated and multiply charged ions. Most of the resources I’ve...

08 August 2024 8,329 0 View

What is the role of oxidative stress in toxin-induced carcinogenesis?

What is the role of oxidative stress in toxin-induced carcinogenesis? I am currently researching the impact of environmental toxins on children's health and would greatly appreciate insights from...

02 August 2024 3,174 1 View

CHO-K1 suspension adaptation protocol?

I am trying to adapt adherent CHO-K1 cells in F12K+10%FBS to suspension culture in only F12K, but in vain. I have followed Mirus bio as well as Thermo protocols, please suggest any alternative....

31 July 2024 3,756 0 View

Given the current level of natural phenomena cause by the climate change and environmental pollution, will the AI find the technological solutions?

AI-driven technologies offer previously unheard-of capabilities to process enormous volumes of data, extract insightful knowledge and improve predictive models, according to the UN’s World...

31 July 2024 9,733 3 View

Where to find a gene list for CRISPRa/i library screening of regulatory factors that affect pathogenic Th17 differentiation in PBMC?

I want to perform a CRISPRa/i library screening for candidate regulatory factors that affect pathogenic Th17 differentiation in PBMC. But I am wondering how to define the size of gene library, so...

31 July 2024 2,150 0 View

Hello dear researchers. I would like to know what is a normalized mass in an EDX analysis?

EDX analisys

31 July 2024 5,947 2 View

Gas chromatography RT detection?

I am working on algal extract to which gas chromatography (Not GC-MS) spectrum I want to discover. My question is can we identify specific compounds using retention time if I compared the RT with...

29 July 2024 8,034 4 View

MAGeCK Plotting Error: Logarithmic Axis Must Have Positive Limits?

I have been running a MAGeCK test command on the terminal for a CRISPR screen to rank sgRNAs and genes based on the read count tables. However, I get only the plot of the top-ranked genes...

28 July 2024 9,811 1 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close