is vortex tube would help to reduce pan evaporation for reservoir?
Even after few repetitions..I am getting similar results. Is is due to organic components?
20 January 2021 9,279 6 View
Researchers from Georgia Tech have developed SBF models to represent biological mechanism. What are advantages and disadvantages of developing and using these SBF models?
29 December 2020 5,098 2 View
Drug permeation through mouse skin Drug deposition in mouse skin Steady-state permeation rate Flux Permeability coefficient Diffusion coefficient Lag time.
10 December 2020 3,808 1 View
Aqueous electrolyte have a potential window of 1.2V, while organic and ionic electrolytes have higher potential windows. But what parameter is contributing to this enhancement in the respective...
19 October 2020 2,447 3 View
Its study for alloxan-induced diabetes in the rabbit.
14 July 2020 2,869 1 View
Give your opnion on said question please.
09 April 2020 1,558 4 View
What are the stress evaluation required for a FEA study on dental implants
09 February 2020 4,382 2 View
I want to use QuiP for impact assessment, what is the process for applying this and in which situation
16 January 2020 314 3 View
What type of force sensors can be used?
08 January 2020 4,098 1 View
Alloxan induced diabetes in the rabbit experiment to perform wound-healing experiments.
21 December 2019 2,724 1 View
The resultant solid was partitioned three times with 250 ml of petroleum ether (40-60/c) to remove any fatty material and evaporated to dryness.
28 February 2021 9,464 2 View
Favourable conditions of base pressure, rate of deposition. Also, by which characterisation technique to be used to verify the thickness of the deposited film.
28 February 2021 3,640 3 View
there are solvents and alcohol in the waste water of a factory that produces disinfectants. Increasing this waste water requires very serious operations. Can I treat this waste water with...
27 February 2021 2,609 3 View
Hi all, I'm doing a transient simulation of flow past a rectangular cylinder close to the free surface. As far as I'm concerned, the common practice is to discard the initial stages of the...
25 February 2021 1,348 3 View
No streamlines present means whether the flow is getting obstructed there and the velocity inside the region is zero? Or else, the fluid is trapped inside that region with a nonzero velocity?...
22 February 2021 5,249 10 View
I want to deposit multilayer coating of germanium and silicon monoxide on silicon wafer using ebeam evaporation?
21 February 2021 2,141 3 View
I've landed on needing some type of highly optically transparent film or cover material that prevents evaporation of culture media; I am not sure which subfield of materials science would be able...
08 February 2021 5,760 1 View
I am trying to prepare a Polyvinyl alcohol membrane for carbondioxide adsorption
08 February 2021 7,493 3 View
Dear I have an air reservoir with 50 bar pressure , this reservoir is fed by 2 bar air pressure source, I would like to instal air pump ( 30 m3/h ) to evacuate the 2 bar fed pressure so I always...
06 February 2021 3,520 3 View
I have to simulate a hydrometallurgical process where there are the following phases: - leaching (solid-liquid reactions) - cementation (solid-liquid reactions) - electrowinning (energy ) -...
30 January 2021 9,225 3 View