Dear researchers,
I am trying to build a rotary rig where I am using a belt for the transmission of rotation from an electric motor to the shaft.
I have same diameter pulley both ends, I measured the trum length and force and based on that I choose the correct belt ( V belt ).
Now I am in the phase of tension the belt where I followed two approaches.
The first I used a digital force meter to the required deflection and I changed the tension of the belt until I achieved the required force per deflection but when I tried to measure the span frequency I did not find the corresponding one. (I used a laser vibrometer to measure the frequency spectrum when I make a hummer punch.
if anyone among you has an experience with that please advise on which method I should follow and if using the laser vibrometer is correct
- Badges
- Science topic
- Similar topics
- Physical Sciences
- Condensed Matter Physics
- Soft Matter
- Liquids