Hi everyone,
I used CST to simulate the current distribution of an antenna. The results are ok but I have a problem with the colour display.
As you can see in the attached file, the colour is somewhat transparent. I would like to have a solid-colour picture.
Could you please help?
Thanks
Set your cutting plane (2D/3D plot) on the location where you to see. Position of cutting plane should be on the either top or bottom of the metallic plate. Than u can see it clearly.
Hello,
Color display actually tells us about intensity and it is already given in right side of results. Each color represents different intensity at each points. If it is not cleared then use vector diagram instead of contour display (color). That will clear all the doubts.
Thanks,
Try to vary parameter shown in figure attached.
Also you can select "SMART SCALING" from Ribbon Box top.
also select the dB Max Plot .
Or also you check Arrows plot in place of "contour display"
May this will help you
- Badges
- Science topic